The finite element analysis of melt flow behaviour in micro-injection moulding
Authors:
- C A GriffithsC A Griffiths
- S S DimovSDS S Dimov
- E B BrousseauEBE B Brousseau
- M S PackianatherMPM S Packianather
- 1 September 2008
- journal article
- research article
- Published by SAGE Publications in Proceedings of the Institution of Mechanical Engineers, Part B: Journal of Engineering Manufacture
- Vol. 222 (9) , 1107-1118
Abstract
Micro-injection moulding as a replication method is one of the key technologies for micromanufacture. The understanding of process constraints for a selected production route is essential both at the design stage and during mass production. In this research, an existing finite element analysis system is used to verify the effects of four process parameters: the melt and mould temperatures, injection speed, and part thickness. Special attention is paid to the melt flow sensitivity when filling microchannels, particularly the factors affecting the shear rate, pressure, and temperature. In particular, the simulation model was used to investigate the flow behaviour of two polymer materials, polypropylene and acrylonitrile butadiene styrene, by varying the process parameters. Then, the results of this investigation were compared with those reported in an experimental study. Conclusions are made about the accuracy and sensitivity of the proposed simulation model.Keywords
This publication has 21 references indexed in Scilit:
- The effects of tool surface quality in micro-injection mouldingJournal of Materials Processing Technology, 2007
- Micro-injection moulding: Factors affecting the achievable aspect ratiosThe International Journal of Advanced Manufacturing Technology, 2006
- An Analytical Non-Newtonian and Nonisothermal Viscous Flow SimulationPolymer-Plastics Technology and Engineering, 2006
- Effect of process parameters on injection compression molding of pickup lensApplied Mathematical Modelling, 2005
- Characterization of the Effect of Surface Roughness and Texture on Fluid Flow: Past, Present, and Future (Keynote)2005
- Implementation and analysis of polymeric microstructure replication by micro injection moldingJournal of Micromechanics and Microengineering, 2003
- Effects of Processing Conditions and Material Models on the Injection Pressure and Flow Length in Thinwall Parts2001
- Numerical analysis of injection molding of glass fiber reinforced thermoplastics. Part 1: Injection pressures and flowPolymer Engineering & Science, 1997
- Hydrodynamic Slip: Polymer Adsorption and Desorption at Melt/Solid InterfacesPhysical Review Letters, 1996
- Stick-Slip Transition at Polymer Melt/Solid InterfacesPhysical Review Letters, 1995