An investigation on the effects of late intake valve closing and exhaust gas recirculation in a single-cylinder research diesel engine in the low-load condition
Authors:
- 27 July 2015
- journal article
- research article
- Published by SAGE Publications in Proceedings of the Institution of Mechanical Engineers, Part D: Journal of Automobile Engineering
- Vol. 230 (6) , 771-787
Abstract
The effects of late intake valve closing and exhaust gas recirculation on the emissions and the engine performance of a single-cylinder diesel research engine were observed. Two cam profiles (symmetric and asymmetric) were implemented using an offset angle at various intake valve closing timings to characterize the engine performance and the emissions. The injection timings were swept at every condition to evaluate the optimal operating conditions. The highest indicated mean effective pressure was observed once the combustion phasing was tuned to the optimum crank angle (in degrees) by varying the injection timing. The indicated mean effective pressure exhibited a slight penalty when both exhaust gas recirculation and late intake valve closing were used in comparison with the base intake valve closing timing with no exhaust gas recirculation. However, an appropriate combination of the exhaust gas recirculation with late intake valve closing was effective in reducing the nitrogen oxide emissions owing to the decreased in-cylinder temperature. The prolonged ignition delay with exhaust gas recirculation and late intake valve closing also contributed to the improvement in the nitrogen oxides–smoke trade-off relationship. The potential for further reduction in the smoke emissions with the asymmetric cam profile was observed. An increase in the in-cylinder swirl motion was expected, which enhanced the air–fuel mixing process.Keywords
This publication has 34 references indexed in Scilit:
- The effects of early inlet valve closing and cylinder disablement on fuel economy and emissions of a direct injection diesel engineEnergy, 2015
- Experimental and numerical study on different dual-fuel combustion modes fuelled with gasoline and dieselApplied Energy, 2014
- Experimental investigation of the effects of diesel injection strategy on gasoline/diesel dual-fuel combustionApplied Energy, 2013
- Numerical evaluation of the potential of late intake valve closing strategy for diesel PCCI (premixed charge compression ignition) engine in a wide speed and load rangeEnergy, 2013
- Numerical investigation of the influence of intake valve lift profile on a diesel premixed charge compression ignition engine with a variable valve actuation system at moderate loads and speedsInternational Journal of Engine Research, 2012
- Numerical analysis of Miller-premixed charge compression ignition combustion on a dynamic φ—T mapInternational Journal of Engine Research, 2010
- Progress and recent trends in homogeneous charge compression ignition (HCCI) enginesProgress in Energy and Combustion Science, 2009
- Effect of advancing the closing angle of the intake valves on diffusion-controlled combustion in a HD diesel engineApplied Thermal Engineering, 2009
- Potential of Atkinson cycle combined with EGR for pollutant control in a HD diesel engineEnergy Conversion and Management, 2009
- The effects of exhaust gas recirculation on diesel combustion and emissionsInternational Journal of Engine Research, 2000