A study on the influence of pick geometry on rock cutting based on full-scale cutting test and simulation
Author:
Open Access
- 1 December 2014
- journal article
- research article
- Published by SAGE Publications in Advances in Mechanical Engineering
- Vol. 12 (12)
Abstract
In this paper, series of full-scale cutting tests and cutting simulations are carried out to investigate the influence of installation parameter and geometry of the pick on cutting performance. The discrete element method is used to simulate the rock cutting process. A general process to calibrate macro properties of rock including uniaxial compressive strength (UCS), elastic modulus, Poisson’s ratio, cohesion and internal friction angle is proposed and used to complete the calibration of coal model. The cutting simulations are performed using picks with different tip angles and rake angles. The results show that the peak cutting force (PCF) decreases with the increase of rake angle following an inverse proportional function when the rake angle is positive, while it varies following a parabolic curve in the condition of negative rake angle. Moreover, the crack mode changes from primarily shear failure to primarily tensile failure with the increase of rake angle. Finally, a multiple-attribute index is proposed to evaluate the cutting performance and select the optimum cutting parameters.Keywords
Funding Information
- National Key Research and Development Program of China (2014CB046301)
- National Natural Science Foundation of China (U1510116 and U1610251)
This publication has 13 references indexed in Scilit:
- Determination of Optimum Tool for Efficient Rock CuttingGeotechnical and Geological Engineering, 2016
- Performance Analysis of Two Different Conical Picks Used in Linear Cutting Operation of CoalArabian Journal for Science and Engineering, 2015
- Studies on the formation of discontinuous chips during rock cutting using an explicit finite element modelThe International Journal of Advanced Manufacturing Technology, 2013
- Full scale linear cutting experiment to examine conical bit rotationJournal of Mining Science, 2012
- Discrete element modeling of tool‐rock interaction I: rock cuttingInternational Journal for Numerical and Analytical Methods in Geomechanics, 2012
- Discrete element simulation of rock cuttingInternational Journal of Rock Mechanics and Mining Sciences, 2011
- Numerical simulation of rock cutting using the discrete element methodInternational Journal of Rock Mechanics and Mining Sciences, 2011
- Dominant rock properties affecting the performance of conical picks and the comparison of some experimental and theoretical resultsInternational Journal of Rock Mechanics and Mining Sciences, 2006
- Distinct Element Modeling of Rock Cutting under Hydrostatic PressureKey Engineering Materials, 2003
- A theory of the cutting force for point-attack picksGeotechnical and Geological Engineering, 1984