Effect of Surface Modifications on the Retention of Cement-retained Implant Crowns under Fatigue Loads
Authors:
Open Access
- 1 November 2017
- journal article
- research article
- Published by Wolters Kluwer Health in Journal of Pharmacy and Bioallied Sciences
- Vol. 9 (Suppl 1) , S154-S160
Abstract
Background: Masticatory forces cause fatigue to the dental luting agents, adversely affecting the retention of these cement-retained crowns. Sandblasting (SB) and diamond abrading the abutment surface improves the bond strength of luting agents. However, the effect of acid etching (AE) on the implant abutment surface and the effect of other surface modifications under masticatory load are yet to be documented. Purpose: The aim of the study was to evaluate the effect of abutment surface modifications on the retention of cement-retained restorations subjected to cyclic fatigue loads. Materials and Methods: Forty Ni-Cr copings were made on Cp-titanium laboratory analogs. The specimens were divided into two groups as Group I: Uniaxial tensile loading (UTL) and Group II: Offaxial cyclic loading followed by uniaxial tensile loading [CTL]. Further subgrouped as, subgroup I: Control (C), subgroup II: SB, subgroup III: AE, and subgroup IV: SB + AE. The copings were luted with Zn 2 (PO 4 ) 3 and subjected to uniaxial tensile loading. Copings were recemented, and CTL was conducted. Two-way analysis of variance was used as the statistical test of significance. Results: In relation to the subgroups, the bond strength of Zn 2 (PO 4 ) 3 was higher in Group I than in Group II. The bond strength in subgroup IV was superior in both Group I and Group II (547.170 N ± 5.752 and 531.975 N ± 6.221 respectively). Conclusions: For both UTL and CTL, abutment SB + AE elicited maximum coping retention followed by AE. Off-axial cyclic loading adversely affected the retention irrespective of the surface modifications.Keywords
This publication has 29 references indexed in Scilit:
- Effects of Abutment and Screw Access Channel Modification on Dislodgement of Cement-Retained Implant-Supported RestorationsThe International Journal of Prosthodontics, 2013
- Influence of abutment height and surface roughness on in vitro retention of three luting agents.2012
- Effect of axial wall modification on the retention of cement-retained, implant-supported crownsThe Journal of Prosthetic Dentistry, 2012
- The effects of height and surface roughness of abutments and the type of cement on bond strength of cement-retained implant restorationsClinical Oral Implants Research, 2010
- The Effect of Engaging the Screw Access Channel of an Implant Abutment with a Cement‐Retained RestorationJournal of Prosthodontics, 2009
- Cement Selection for Cement‐Retained Crown Technique with Dental ImplantsJournal of Prosthodontics, 2007
- The Effects of Abutment Wall Height, Platform Size, and Screw Access Channel Filling Method on Resistance to Dislodgement of Cement‐Retained, Implant‐Supported RestorationsJournal of Prosthodontics, 2007
- Retention forces and seating discrepancies of implant-retained castings after cementation.2006
- Retention of luting agents on implant abutments of different height and taperClinical Oral Implants Research, 2005
- The effects of abutment taper, length and cement type on resistance to dislodgement of cement‐retained, implant‐supported restorationsJournal of Prosthodontics, 2003