Quantifying PM2.5 Source Contributions for the San Joaquin Valley with Multivariate Receptor Models
- 9 March 2007
- journal article
- research article
- Published by American Chemical Society (ACS) in Environmental Science & Technology
- Vol. 41 (8) , 2818-2826
Abstract
UNMIX and Positive Matrix Factorization (PMF) solutions to the Chemical Mass Balance (CMB) equations were applied to chemically speciated PM2.5 measurements from 23 sites in California's San Joaquin Valley to estimate source contributions. Six and seven factors were determined by UNMIX for the low_PM2.5 period (February to October) and high_PM2.5 period (November to January), respectively. PMF resolved eight factors for each period that corresponded with the UNMIX factors in chemical profiles and time series. These factors are attributed to marine sea salt, fugitive dust, agriculture−dairy, cooking, secondary aerosol, motor vehicle, and residential wood combustion (RWC) emissions, with secondary aerosol and RWC accounting for over 70% of PM2.5 mass during the high_PM2.5 period. A zinc factor was only resolved by PMF. The contribution from motor vehicles was between 10 and 25% with higher percentages occurring in summer. The PMF model was further evaluated by examining (1) site-specific residuals between the measured and calculated concentrations, (2) comparability of motor vehicle and RWC factors against source profiles obtained from recent emission tests, (3) edges in bi-plots of key indicator species, and (4) spatiotemporal variations of the factors' strengths. These evaluations support the compliance with model assumptions and give a higher confidence level to source apportionment results for the high_PM2.5 period.Keywords
This publication has 19 references indexed in Scilit:
- A comparison of the UCD/CIT air quality model and the CMB source–receptor model for primary airborne particulate matterAtmospheric Environment, 2005
- Evaluation of secondary organic aerosol formation in winterAtmospheric Environment, 1999
- Spatial and temporal variations in PM10 and PM2.5 source contributions and comparison to emissions during the 1995 integrated monitoring studyAtmospheric Environment, 1999
- Composition of Light-Duty Motor Vehicle Exhaust Particulate Matter in the Denver, Colorado AreaEnvironmental Science & Technology, 1999
- Positive matrix factorization: A non‐negative factor model with optimal utilization of error estimates of data valuesEnvironmetrics, 1994
- The application of three-mode factor analysis (TMFA) to receptor modeling of SCENES particle dataAtmospheric Environment. Part A. General Topics, 1992
- A method for classification of wind field patterns and its application to southern CaliforniaInternational Journal of Climatology, 1992
- The effective variance weighting for least squares calculations applied to the mass balance receptor modelAtmospheric Environment (1967), 1984
- Multielemental characterization of urban roadway dustEnvironmental Science & Technology, 1980
- A quantitative determination of sources in the Boston urban aerosolAtmospheric Environment (1967), 1980