Design and fabrication of a broadband polymer vertically coupled optical switch
- 13 February 2006
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Lightwave Technology
- Vol. 24 (2) , 904-911
Abstract
This paper presents a detailed design and fabrication of a composite broadband polymer vertically coupled optical switch with a spectral extinction ratio variation less than 1 dB for the cross state and 2.5 dB for the bar state. This switch consists of two pairs of basic three-dimensional (3-D) polymer switches with peak coupling wavelengths located at the two ends of the C-band, respectively. The resultant extinction ratio is shown to be the sum of the individual ratios of the two basic switches that the optical signal propagates through. The rise time and fall time of switching are 1.0 and 1.5 ms, respectively, and the total electric power applied to the electrode heater is about 140 mW.Keywords
This publication has 9 references indexed in Scilit:
- Design and fabrication of a three-dimensional polymer optical waveguide polarization splitterOptics Communications, 2005
- A vertically coupled polymer optical waveguide switchOptics Communications, 2005
- Vertical Digital Thermooptic Switch in PolymerIEEE Photonics Technology Letters, 2004
- Fully packaged polymeric four arrayed 2 x 2 digital optical switchIEEE Photonics Technology Letters, 2002
- Thermo-optic vertical coupler switches using hybridpolymer/silica integration technologyElectronics Letters, 2000
- Three-dimensional integrated optics using polymersIEEE Journal of Quantum Electronics, 1999
- Vertically integrated waveguide polarization splitters using polymersIEEE Photonics Technology Letters, 1999
- Three-dimensional coupled mode method for simulation of coupler and filter structuresJournal of Lightwave Technology, 1992
- Coupling characteristics of two rectangular dielectric waveguides laid in different layersIEEE Journal of Quantum Electronics, 1986