Effect of Oxygen Content Upon the Microstructural and Mechanical Properties of Type 316L Austenitic Stainless Steel Manufactured by Hot Isostatic Pressing
Authors:
Open Access
- 22 June 2016
- journal article
- research article
- Published by Springer Nature in Metallurgical and Materials Transactions A
- Vol. 47 (9) , 4467-4475
Abstract
Although hot isostatic pressing (HIP) has been shown to demonstrate significant advances over more conventional manufacture routes, it is important to appreciate and quantify the detrimental effects of oxygen involvement during the HIP manufacture process on the microstructural and material properties of the resulting component. This paper quantifies the effects of oxygen content on the microstructure and Charpy impact properties of HIP’d austenitic stainless steel, through combination of detailed metallographic examination and mechanical testing on HIP’d Type 316L steel containing different concentrations (100 to 190 ppm) of oxygen. Micron-scale pores were visible in the microstructure of the HIP’d materials postmetallographic preparation, which result from the removal of nonmetallic oxide inclusions during metallographic preparation. The area fraction of the resulting pores is shown to correlate with the oxygen concentration which influences the Charpy impact toughness over the temperature range of 77 K to 573 K (−196 °C to 300 °C), and demonstrates the influence of oxygen involved during the HIP manufacture process on Charpy toughness. The same test procedures and microstructural analyses were performed on commercially available forged 316L. This showed comparatively fewer inclusions and exhibited higher Charpy impact toughness over the tested temperature range.Keywords
This publication has 12 references indexed in Scilit:
- Effect of oxygen content on impact toughness of a fine-grained magnesium alloyMaterials Letters, 2011
- Relation between microstructure and Charpy impact properties of an elemental and pre-alloyed 14Cr ODS ferritic steel powder after hot isostatic pressingJournal of Materials Science, 2010
- Challenges and advances in nanocomposite processing techniquesMaterials Science and Engineering: R: Reports, 2006
- The effect of reduced oxygen content powder on the impact toughness of 316 steel powder joined to 316 steel by low temperature HIPFusion Engineering and Design, 2005
- Fundamental aspects of hot isostatic pressing: An overviewMetallurgical and Materials Transactions A, 2000
- Near net shape production of monolithic and composite high temperature ceramics by hot isostatic pressing (HIP)Journal of the European Ceramic Society, 1999
- Near-net-shape forming of 316L stainless steel powder under hot isostatic pressingInternational Journal of Mechanical Sciences, 1999
- Microstructure and property relationships in hipped Stellite powdersPowder Metallurgy, 1999
- High performance stainless steel via powder metallurgy hot isostatic pressingMaterials Science and Technology, 1997
- Oxygen content and fracture toughness on MIG weld metal of SUS304 steel.QUARTERLY JOURNAL OF THE JAPAN WELDING SOCIETY, 1985