Preventing PCM banks from seizing too much power
Authors:
Open Access
- 3 December 2011
- conference paper
- Published by Association for Computing Machinery (ACM)
- p. 186-195
Abstract
Widespread adoption of Phase Change Memory (PCM) requires solutions to several problems recently addressed in the literature, including limited endurance, increased write latencies, and system-level changes required to exploit non-volatility. One important difference between PCM and DRAM that has received less attention is the increased need for write power management. Writing to a PCM cell requires high current density over hundreds of nanoseconds, and hard limits on the number of simultaneous writes must be enforced to ensure correct operation, limiting write throughput and therefore overall performance. Because several wear reduction schemes only write those bits that need to be written, the amount of power required to write a cache line back to memory under such a system is now variable, which creates opportunity to reduce write power. This paper proposes policies that monitor the bits that have actually been changed over time, as opposed to simply those lines that are dirty. These polices can more effectively allocate power across the system to improve write concurrency. This method for allocating power across the memory subsystem is built on the idea of "power tokens," a transferable, but time-specific, allocation of power. The results show that with a storage overhead of 4.3% in the last-level cache, a power-aware memory system can improve the performance of multiprogrammed workloads by up to 84%.Keywords
This publication has 19 references indexed in Scilit:
- SAFER: Stuck-At-Fault Error Recovery for Memories2010
- Improving read performance of Phase Change Memories via Write Cancellation and Write Pausing2010
- Enhancing lifetime and security of PCM-based main memory with start-gap wear leveling2009
- Flip-N-Write2009
- Scalable high performance main memory system using phase-change memory technology2009
- Architecting phase change memory as a scalable dram alternative2009
- A Low Power Phase-Change Random Access Memory using a Data-Comparison Write Scheme2007
- SPEC CPU2006 benchmark descriptionsACM SIGARCH Computer Architecture News, 2006
- Pin2005
- Using SimPoint for accurate and efficient simulationACM SIGMETRICS Performance Evaluation Review, 2003