Extraction of Am(iii) using novel solvent systems containing a tripodal diglycolamide ligand in room temperature ionic liquids: a ‘green’ approach for radioactive waste processing
Authors:
- 13 June 2012
- journal article
- research article
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 2 (19) , 7492-7500
Abstract
Extraction of Am3+ from acidic feed solutions was investigated using novel solvent systems containing a tripodal diglycolamide (T-DGA) in three room temperature ionic liquids (RTIL), viz. [C4mim][NTf2], [C6mim][NTf2] and [C8mim][NTf2]. Compared to the results obtained with N,N,N′,N′-tetra-n-octyl diglycolamide (TODGA), T-DGA gave significantly higher distribution coefficients in these RTILs. The DAm values decreased with increasing carbon chain length in the RTILs, which was related to the solubility of the RTIL in the aqueous phase. The distribution studies included the effect of equilibration time, aqueous phase acid concentration variation and T-DGA concentration variation. In general, significantly higher equilibration times were observed for the extraction systems, which was partly due to the viscous RTIL phase and partly due to the slow conformational changes of the T-DGA ligand during complexation. Apart from Am3+, extraction of Pu4+, UO2 2+, Eu3+, Sr2+ and Cs+ was also investigated, since they have significant implications in radioactive waste processing. Stripping studies indicated >99% stripping in three stages using 0.5 M EDTA or DTPA in 1 M guanidine carbonate. Slope analysis indicated the extraction of 1 : 1 complexed species of Am(III) with T-DGA. Time resolved laser fluorescence spectroscopy (TRLFS) studies showed a strong complexation with no inner-sphere water molecules in the Eu(III)–T-DGA complexes for [C4mim][NTf2] as the diluent. Radiolytic degradation studies of the solvent systems containing T-DGA in the three RTILs were also carried out and while the DAm values decreased marginally when the solvents were exposed to 500 kGy absorbed dose, a relatively sharp decrease (60%) was seen when the solvents were exposed further to 1000 kGy absorbed dose, suggesting the possibility of recycling. Extraction studies were also carried out at varying temperatures and the thermodynamic parameters were calculated.Keywords
This publication has 45 references indexed in Scilit:
- Evaluation of a novel tripodal diglycolamide for actinide extraction: Solvent extraction and SLM transport studiesJournal of Membrane Science, 2011
- Studies on the use ofN,N,N′,N′-Tetra(2-Ethylhexyl) Diglycolamide (TEHDGA) for Actinide Partitioning II: Investigation on Radiolytic StabilitySolvent Extraction and Ion Exchange, 2011
- Extraction of Alkaline Earth Metal Ions with TODGA in the Presence of Ionic LiquidsSolvent Extraction and Ion Exchange, 2010
- Efficient removal of caesium ions from aqueous solution using a calix crown ether in ionic liquids: mechanism and radiation effectDalton Transactions, 2010
- Static Dielectric Constant of Room Temperature Ionic Liquids: Internal Pressure and Cohesive Energy Density ApproachThe Journal of Physical Chemistry B, 2008
- Tripodal diglycolamides as highly efficient extractants for f-elementsNew Journal of Chemistry, 2007
- Solvent extraction of U(vi) by task specific ionic liquids bearing phosphoryl groupsGreen Chemistry, 2007
- Traditional Extractants in Nontraditional Solvents: Groups 1 and 2 Extraction by Crown Ethers in Room-Temperature Ionic LiquidsIndustrial & Engineering Chemistry Research, 2000
- Enantioselective allylic substitution catalyzed by Pd0–ferrocenylphosphine complexes in [bmim][PF6] ionic liquidGreen Chemistry, 2000
- Solvent extraction of strontium nitrate by a crown ether using room-temperature ionic liquids †J. Chem. Soc., Dalton Trans., 1999