Design, Fabrication, and Testing of a Microfabricated Corona Ionizer
Authors:
- Beelee ChuaBeelee Chua
- Anthony S. WexlerAWAnthony S. Wexler
- Norman C. TienNTNorman C. Tien
- Debbie A. NiemeierDNDebbie A. Niemeier
- Britt A. HolmenBHBritt A. Holmen
- 7 February 2008
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Microelectromechanical Systems
- Vol. 17 (1) , 115-123
Abstract
A microfabricated corona ionizer is developed for miniaturized air particle monitoring instruments. Peek's breakdown criterion and Warburg's Law are used to calculate the required electrode geometries. Single mask electroplating is employed as the microfabrication technique. Devices with discharge pin radius of 20 mum and interelectrode spacing of 1.4, 1.8, 2.0, and 2.2 mm are fabricated and tested. The inception voltages in the range from 1.4 to 2 kV are achieved without substrate breakdown. It consumes relatively low power at 150 mW or less. Corona charging currents of more than 50 muA were achieved before streamers break down. The experimental results also demonstrated the nondependency of the inception voltage on the pin's radius of curvature so long as it is significantly smaller than the interelectrode spacing. There is only one value of inception voltage for each given interelectrode spacing (1.4 to 2.2 mm) with the pin's radius of curvature ranging from 10 to 200 mum. This implies that strict dimensional control is not required in the microfabrication process in order to ensure the same inception voltage for each device.Keywords
This publication has 22 references indexed in Scilit:
- A Micro corona motor fabricated by a SU-8 built-on X-ray maskMicrosystem Technologies, 2004
- Electrical breakdown in atmospheric air between closely spaced (0.2 μm-40 μm) electrical contactsIEEE Transactions on Components and Packaging Technologies, 2002
- Micro-discharge and electric breakdown in a micro-gapJournal of Micromechanics and Microengineering, 2000
- A micromachined electron beam ion sourceSensors and Actuators B: Chemical, 2000
- Positive corona inception in HVDC configurations under variable air density and humidity conditionsThe European Physical Journal Applied Physics, 2000
- Why Paschen's law does not apply in low-pressure gas discharges with inhomogeneous fieldsJournal of Physics D: Applied Physics, 1995
- Theory of electrical breakdown in air-the role of metastable oxygen moleculesJournal of Physics D: Applied Physics, 1992
- Derivation of the current-potential equation for steady point-to-plane corona dischargesJournal of Applied Physics, 1982
- A derivation of Warburg’s law for point to plane coronasJournal of Applied Physics, 1981
- Ueber die zum Funkenübergang in Luft, Wasserstoff und Kohlensäure bei verschiedenen Drucken erforderliche PotentialdifferenzAnnalen der Physik, 1889