Dry ball milling and wet ball milling for fabricating copper–yttria composites
Authors:
- 4 July 2018
- journal article
- research article
- Published by Wiley in Rare Metals
- Vol. 37 (10) , 859-867
Abstract
Yttria‐reinforced copper matrix composites were prepared by dry ball milling (DBM) and wet ball milling (WBM), respectively, followed by spark plasma sintering (SPS). It is to determine which milling process is better for fabricating Cu–Y 2 O 3 composites. It is found that Cu–Y 2 O 3 composites synthesized by DBM exhibit better densification, mechanical and electrical properties than those by WBM. Less agglomeration of reinforcements in the bulk composites by DBM is responsible for the better performances. To further understand the reason of less agglomeration of Y 2 O 3 in the bulks by DBM, morphologies of prepared powders were investigated and analyzed. Higher ball's impact energy and the formation of copper oxide on the matrix surface during DBM process contribute to small matrix particles, which is beneficial for less agglomeration.Keywords
Funding Information
- the national key Research and Development Program of China (2016YFB0301401)
- National Key Research and Development Program of China (2016YFB0301401)
This publication has 35 references indexed in Scilit:
- Effects of milling methods on the dielectric and the mechanical properties of hot-pressed sintered MoSi2/Al2O3 compositesJournal of Alloys and Compounds, 2011
- Influence of dry and wet grinding conditions on fineness and shape of particle size distribution of product in a ball millAdvanced Powder Technology, 2011
- Effects of ball milling time on the synthesis and consolidation of nanostructured WC–Co compositesInternational Journal of Refractory Metals and Hard Materials, 2009
- Preparation of micron-sized flake copper powder for base-metal-electrode multi-layer ceramic capacitorJournal of Materials Processing Technology, 2009
- Solid state and liquid phase sintering of mechanically activated W–20wt.% Cu powder mixtureJournal of Alloys and Compounds, 2008
- Nanostructured WC/Co composite powder prepared by high energy ball millingScripta Materialia, 2003
- Effect of Milling Conditions on the Strength of Alumina–Silicon Carbide NanocompositesJournal of the American Ceramic Society, 1997
- Preparation of Fine AlN Powders by Wet Ball-Milling and Their CharacterizationJournal of the Ceramic Society of Japan, 1997
- Ball milling of ductile metalsMaterials Science and Engineering: A, 1995
- Wear of Media Balls during the Ball Milling of Si3N4 PowderJournal of the Ceramic Society of Japan, 1993