The Effects of Bit Wear on Respirable Silica Dust, Noise and Productivity: A Hammer Drill Bench Study
Open Access
- 8 June 2017
- journal article
- research article
- Published by Oxford University Press (OUP) in Annals of Work Exposures and Health
- Vol. 61 (6) , 700-710
Abstract
Hammer drills are used extensively in commercial construction for drilling into concrete for tasks including rebar installation for structural upgrades and anchor bolt installation. This drilling task can expose workers to respirable silica dust and noise. The aim of this pilot study was to evaluate the effects of bit wear on respirable silica dust, noise, and drilling productivity. Test bits were worn to three states by drilling consecutive holes to different cumulative drilling depths: 0, 780, and 1560 cm. Each state of bit wear was evaluated by three trials (nine trials total). For each trial, an automated laboratory test bench system drilled 41 holes 1.3 cm diameter, and 10 cm deep into concrete block at a rate of one hole per minute using a commercially available hammer drill and masonry bits. During each trial, dust was continuously captured by two respirable and one inhalable sampling trains and noise was sampled with a noise dosimeter. The room was thoroughly cleaned between trials. When comparing results for the sharp (0 cm) versus dull bit (1560 cm), the mean respirable silica increased from 0.41 to 0.74 mg m−3 in sampler 1 (P = 0.012) and from 0.41 to 0.89 mg m−3 in sampler 2 (P = 0.024); levels above the NIOSH recommended exposure limit of 0.05 mg m−3. Likewise, mean noise levels increased from 112.8 to 114.4 dBA (P < 0.00001). Drilling productivity declined with increasing wear from 10.16 to 7.76 mm s−1 (P < 0.00001). Increasing bit wear was associated with increasing respirable silica dust and noise and reduced drilling productivity. The levels of dust and noise produced by these experimental conditions would require dust capture, hearing protection, and possibly respiratory protection. The findings support the adoption of a bit replacement program by construction contractors.Keywords
Funding Information
- National Institute for Occupational Safety and Health (U60-2-OH009762)
This publication has 15 references indexed in Scilit:
- Evaluation of a Dust Control for a Small Slab-Riding Dowel Drill for Concrete PavementAnnals of Occupational Hygiene, 2016
- Auditory and non-auditory effects of noise on healthThe Lancet, 2014
- The effectiveness of DustBubbles on dust control in the process of concrete drillingSafety Science, 2012
- Case StudyJournal of Occupational and Environmental Hygiene, 2012
- Silica Exposure on Construction Sites: Results of an Exposure Monitoring Data Compilation ProjectJournal of Occupational and Environmental Hygiene, 2006
- Surveillance of hearing loss among older construction and trade workers at Department of Energy nuclear sitesAmerican Journal of Industrial Medicine, 2005
- Surveillance of respiratory diseases among construction and trade workers at Department of Energy nuclear sitesAmerican Journal of Industrial Medicine, 2003
- Noise Levels of Selected Construction TasksAIHA Journal, 2002
- Exposure Characterization for Highway Construction Part I: Cut and Cover and Tunnel Finish StagesApplied Occupational and Environmental Hygiene, 1999
- Case Studies: Silica Exposure for Concrete Workers and MasonsApplied Occupational and Environmental Hygiene, 1993