Microstructure and mechanical behavior of nanostructured composite Cu60Fe40alloy
Authors:
- 1 February 2011
- journal article
- research article
- Published by Taylor & Francis in Philosophical Magazine Letters
- Vol. 91 (2) , 78-85
Abstract
In this study, bulk nanostructured composite Cu60Fe40 alloy is prepared by a combustion synthesis technique. The prepared Cu60Fe40 alloy consists of Cu(Fe) solid solution and Fe(Cu) solid solution phases. The large-scaled compositional segregation in the Cu-rich and Fe-rich phases is not observed, respectively. A few micron-sized dendrite (Fe(Cu) solid solution) is embedded into the nanostructured matrix (Cu(Fe) solid solution). The grain size of the matrix is in the range 50–300 nm. The yield and fracture strength of the Cu60Fe40 alloy are 540 and 1050 MPa, respectively, and the fracture strain obtained from the compression test is about 20.9%. The Cu60Fe40 alloy displays notable work hardening in the compressive deformation.Keywords
This publication has 19 references indexed in Scilit:
- The microstructure and mechanical properties of Fe–Cu materials fabricated by pressure-less-shaping of nanocrystalline powdersJournal of Materials Science, 2007
- Mechanical properties of nanocrystalline materialsProgress in Materials Science, 2006
- Behavior of Fe-rich phase during rapid solidification of Cu–Fe hypoperitectic alloyMaterials Science and Engineering: A, 2005
- Alloys created between immiscible elementsProgress in Materials Science, 2005
- Investigation of Ti–Fe–Co bulk alloys with high strength and enhanced ductilityActa Materialia, 2005
- Tensile behavior change depending on the microstructure of a Fe–Cu alloy produced from rapidly solidified powderMaterials Science and Engineering: A, 2003
- Microstructure evolution of undercooled iron–copper hypoperitectic alloyMaterials Science and Engineering: A, 2001
- Critical-point wetting at the metastable chemical binodal in undercooled Fe–Cu alloysActa Materialia, 1999
- Microstructure and strength of CuFe in Situ composites after very high drawing strainsActa Materialia, 1996
- Thermodynamic and kinetic aspects of the crystal to glass transformation in metallic materialsProgress in Materials Science, 1986