Stall Margin Improvement in a Transonic Compressor With a Casing Treatment: Flow Mechanism
Author:
- 4 November 2022
- journal article
- research article
- Published by Wiley in Journal of Turbomachinery
- Vol. 145 (4) , 1-17
Abstract
A compressor casing treatment with circumferential casing grooves (CCGs) is studied in detail. The primary objective of the current paper is to unearth the main driving fluid mechanism that changes the stall margin in a transonic compressor with CCGs. Large eddy simulation (LES) is applied to calculate the transonic compressor flow fields with and without CCGs. The present investigation shows that CCGs reduce the mass flow through the tip gap by about 16% near the stall condition. Calculated flow fields show that most of this reduction of tip leakage flow occurs near the CCGs. Reinjected flow from the CCGs pushes the tip leakage flow radially inward below the casing and changes how the tip leakage flow collides with the incoming main passage flow. However, a detailed examination of the calculated flow in the tip region shows that the reinjected flow does not contribute to the reduction of the overall blockage generation. The primary driver for reducing blockage generation with CCGs is the reduction of overall mass flowrate through the tip gap. In the present investigation, measurements show a very small decrease in efficiency with CCGs at the design flow condition, although the difference in efficiency is within the measurement uncertainty. Results from the LES simulation at the design condition with CCGs show that the tip leakage vortex (TLV) is pulled toward the blade suction side and double leakage flow is eliminated. The result is that the simulated efficiencies with and without CCGs are almost the same.Keywords
This publication has 14 references indexed in Scilit:
- Numerical Analysis of Flow in a Transonic Compressor With a Single Circumferential Casing Groove: Influence of Groove Location and Depth on Flow InstabilityJournal of Turbomachinery, 2013
- Enhancing the Stability of Subsonic Compressors Using Casing GroovesJournal of Turbomachinery, 2010
- Investigation of Blade Tip Interaction With Casing Treatment in a Transonic Compressor: Part 1—Particle Image Velocimetry2008
- Flow Mechanism for Stall Margin Improvement due to Circumferential Casing Grooves on Axial CompressorsJournal of Turbomachinery, 2004
- The Effect of Tip Clearance on a Swept Transonic Compressor RotorJournal of Turbomachinery, 1996
- Numerical Simulation of Compressor Endwall and Casing Treatment Flow PhenomenaJournal of Turbomachinery, 1993
- A dynamic subgrid-scale eddy viscosity modelPhysics of Fluids A: Fluid Dynamics, 1991
- Effects of Endwall Suction and Blowing on Compressor Stability EnhancementJournal of Turbomachinery, 1990
- Flow Phenomena in Compressor Casing TreatmentJournal of Engineering for Gas Turbines and Power, 1984
- Stall Margin Improvement by Casing Treatment—Its Mechanism and EffectivenessJournal of Engineering for Power, 1977