Comparison of calorimetric plasma diagnostics in a plasma downstream reactor
Authors:
- C RothCRC Roth
- S BornholdtSBS Bornholdt
- H KerstenHKH Kersten
- 15 February 2011
- journal article
- Published by IOP Publishing in Journal of Physics D: Applied Physics
- Vol. 44 (9)
Abstract
The energy influx in a non-equilibrium plasma in the afterglow of a plasma downstream reactor has been measured by two different calorimetric probe types. The radio frequency discharge is investigated for oxygen (10–100%)–argon (90–0%) mixtures at relatively high gas flow rates (750–3000 sccm) and pressures (100–350 Pa). The main process parameters influencing the energy influx are the plasma power, the system pressure and the total gas flow rate. Even though the size, geometry and material composition of the used probe types are different, comparable energy flux values are achieved. Depending on the process parameters, energy fluxes between around 100 and 3500 W m−2 are found and the variation of the pressure and total gas flow rate suggests a highly flow-dependent plasma density distribution in the reactor.Keywords
This publication has 20 references indexed in Scilit:
- Energy flux measurements in high power impulse magnetron sputteringJournal of Physics D: Applied Physics, 2009
- Thermal Characterization and Optimization of a Plasma Downstream Reactor for Particle Surface ModificationPlasma Processes and Polymers, 2009
- Application of Plasma Surface Treatment to Solid‐State Microscopic ParticulatesPlasma Processes and Polymers, 2009
- Flowability Modification of Lactose Powder by Plasma Enhanced Chemical Vapor DepositionPlasma Processes and Polymers, 2007
- Short-time plasma surface modification of HDPE powder in a Plasma Downer Reactor – process, wettability improvement and ageing effectsApplied Surface Science, 2005
- The energy balance at substrate surfaces during plasma processingVacuum, 2001
- Investigations on the energy influx at plasma processes by means of a simple thermal probeThin Solid Films, 2000
- Energy influx from an rf plasma to a substrate during plasma processingJournal of Applied Physics, 2000
- Thermal power at a substrate during ZnO:Al thin film deposition in a planar magnetron sputtering systemJournal of Applied Physics, 1997
- Substrate heating in cylindrical magnetron sputtering sourcesThin Solid Films, 1978