Effect of Blending and Emulsification on Thermal Behavior, Solid Fat Content, and Microstructure Properties of Palm Oil‐Based Margarine Fats
Authors:
- A.A. AriffinAAA.A. Ariffin
- H.M. GhazaliHGH.M. Ghazali
- M.S. MiskandarMMM.S. Miskandar
- S.M. AbdulkarimSAS.M. Abdulkarim
- H.C. BooHBH.C. Boo
- 1 December 2010
- journal article
- research article
- Published by Wiley in Journal of Food Science
- Vol. 76 (1) , C21-C30
Abstract
Abstract: The ability of palm oil (PO) to crystallize as beta prime polymorph has made it an attractive option for the production of margarine fat (MF). Palm stearin (PS) expresses similar crystallization behavior and is considered one of the best substitutes of hydrogenated oils due to its capability to impart the required level of plasticity and body to the finished product. Normally, PS is blended with PO to reduce the melting point at body temperature (37 °C). Lipid phase, formulated by PO and PS in different ratios were subjected to an emulsification process and the following analyses were done: triacylglycerols, solid fat content (SFC), and thermal behavior. In addition, the microstructure properties, including size and number of crystals, were determined for experimental MFs (EMFs) and commercial MFs (CMFs). Results showed that blending and emulsification at PS levels over 40 wt% significantly changed the physicochemical and microstructure properties of EMF as compared to CMF, resulting in a desirable dipalmitoyl‐oleoyl‐glycerol content of less than 36.1%. SFC at 37 °C, crystal size, crystal number, crystallization, and melting enthalpies (Δ H ) were 15%, 5.37 μm, 1425 crystal/μm 2 , 17.25 J/g, and 57.69J/g, respectively. All data reported indicate that the formation of granular crystals in MFs was dominated by high‐melting triacylglycerol namely dipalmitoyl‐oleoyl‐glycerol, while the small dose of monoacylglycerol that is used as emulsifier slowed crystallization rate. Practical Application: Most of the past studies were focused on thermal behavior of edible oils and some blends of oils and fats. The crystallization of oils and fats are well documented but there is scarce information concerning some mechanism related to crystallization and emulsification. Therefore, this study will help to gather information on the behavior of emulsifier on crystallization regime; also the dominating TAG responsible for primary granular crystal formations, as well as to determine the best level of stearin to impart the required microstructure properties and body to the finished products.Keywords
This publication has 25 references indexed in Scilit:
- Effects of chemical interesterification on physicochemical properties of blends of palm stearin and palm oleinFood Research International, 2009
- The Production of an Experimental Table Margarine Enriched with Conjugated Linoleic Acid (CLA): Physical PropertiesJournal of the American Oil Chemists' Society, 2009
- trans-Free Margarines Prepared with Canola Oil/Palm Stearin/Palm Kernel Oil-Based Structured LipidsJournal of Agricultural and Food Chemistry, 2008
- Some properties of margarines and shortenings marketed in TurkeyJournal of Food Composition and Analysis, 2006
- Physicochemical characteristics of palm oil and sunflower oil blends fractionated at different temperaturesFood Chemistry, 2005
- Physical and textural characteristics of hydrogenated low‐erucic acid rapeseed oil and low‐erucic acid rapeseed oil blendsJournal of the American Oil Chemists' Society, 2003
- Physical and chemical properties of a lipase-transesterified palm stearin/palm kernel olein blend and its isopropanol-solid and high melting triacylglycerol fractionsFood Chemistry, 2001
- Crystallization behavior of 1,3-dipalmitoyl-2-oleoyl-glycerol and 1-palmitoyl-2,3-dioleoyl-glycerolEuropean Journal of Lipid Science and Technology, 2001
- Physical properties of lipase-catalyzed transesterified blends of palm stearin and anhydrous milk fatFood Chemistry, 2000
- Composition and thermal profile of crude palm oil and its productsJournal of the American Oil Chemists' Society, 1999