Effect of Gas/Oil Capillary Pressure on Minimum Miscibility Pressure for Tight Reservoirs
Authors:
- 31 December 2019
- journal article
- Published by Society of Petroleum Engineers (SPE) in SPE Journal
- Vol. 25 (02) , 820-831
Abstract
Shale and tight reservoir rocks have pore throats on the order of nanometers, and, subsequently, a large capillary pressure. When the permeability is ultralow (k < 200 nd), as in many shale reservoirs, diffusion might dominate over advection, so that the gas injection might no longer be controlled by the multicontact minimum miscibility pressure (MMP). For gasfloods in tight reservoirs, where k > 200 nd and capillary pressure is still large, however, advection likely dominates over diffusive transport, so that the MMP once again becomes important. This paper focuses on the latter case to demonstrate that the capillary pressure, which has an impact on the fluid pressure/volume/temperature (PVT) behavior, can also alter the MMP. The results show that the calculation of the MMP for reservoirs with nanopores is affected by the gas/oil capillary pressure, owing to alteration of the key tie lines in the displacement; however, the change in the MMP is not significant. The MMP is calculated using three methods: the method of characteristics (MOC); multiple mixing cells; and slimtube simulations. The MOC method relies on solving hyperbolic equations, so the gas/oil capillary pressure is assumed to be constant along all tie lines (saturation variations are not accounted for). Thus, the MOC method is not accurate away from the MMP but becomes accurate as the MMP is approached when one of the key tie lines first intersects a critical point (where the capillary pressure then becomes zero, making saturation variations immaterial there). Even though the capillary pressure is zero for this key tie line, its phase compositions (and, hence, the MMP) are impacted by the alteration of all other key tie lines in the composition space by the gas/oil capillary pressure. The reason for the change in the MMP is illustrated graphically for quaternary systems, in which the MMP values from the three methods agree well. The 1D simulations (typically slimtube simulations) show an agreement with these calculations as well. We also demonstrate the impact of capillary pressure on CO2-MMP for real reservoir fluids. The effect of large gas/oil capillary pressure on the characteristics of immiscible displacements, which occur at pressures well below the MMP, is discussed.Keywords
This publication has 31 references indexed in Scilit:
- Effect of Capillary Pressure on Phase Behavior in Tight Rocks and ShalesSPE Reservoir Evaluation & Engineering, 2013
- Multiple-Mixing-Cell Method for MMP CalculationsSPE Journal, 2011
- Vapor−Liquid Phase Coexistence, Critical Properties, and Surface Tension of Confined AlkanesThe Journal of Physical Chemistry C, 2009
- A new mechanistic Parachor model to predict dynamic interfacial tension and miscibility in multicomponent hydrocarbon systemsJournal of Colloid and Interface Science, 2006
- Critical shift of a confined fluid in a nanoporeFluid Phase Equilibria, 2004
- Effect of Dispersion on Local Displacement Efficiency for Multicomponent Enriched-Gas Floods Above the Minimum Miscibility EnrichmentSPE Reservoir Evaluation & Engineering, 2002
- Analytical calculation of minimum miscibility pressureFluid Phase Equilibria, 1997
- Miscible Gas Displacement of Multicomponent OilsSPE Journal, 1996
- Determination and Prediction of CO2 Minimum Miscibility Pressures (includes associated paper 8876 )Journal of Petroleum Technology, 1980
- A New Two-Constant Equation of StateIndustrial & Engineering Chemistry Fundamentals, 1976