Back‐Face Strain for Monitoring Stable Crack Extension in Precracked Flexure Specimens
- 12 April 2010
- journal article
- Published by Wiley in Journal of the American Ceramic Society
- Vol. 93 (9) , 2804-2813
Abstract
Calibrations relating back‐face strain (BFS) to crack length in precracked flexure specimens were developed for different strain gage sizes. The functions were verified via experimental compliance measurements of notched and precracked ceramic beams. Good agreement between the functions and experiments occurred, and fracture toughness was calculated using several operational methods: maximum test load and optically measured precrack length; load at 2% crack extension and optical precrack length; and maximum load and BFS crack length. All the methods gave comparable results. The initiation toughness, K Ii , was also estimated from the initial compliance and load. The results demonstrate that the stability of precracked ceramic specimens tested in four‐point flexure is a common occurrence, and that methods such as remotely monitored load‐point displacement are only adequate for detecting stable extension of relatively deep cracks.Keywords
This publication has 17 references indexed in Scilit:
- Test method variability in slow crack growth properties of sealing glassesInternational Journal of Fatigue, 2010
- Method to Estimate Crack‐Tip Toughness from Bending Tests on Prenotched BarsJournal of the American Ceramic Society, 2000
- Stress Intensity Factor Coefficients for Chevron-Notched Flexure Specimens and a Comparison Fracture Toughness Methods1999
- Fracture Toughness of Ceramics Using the Sevnb Method: Preliminary Results1997
- Crack Stability and Its Effect on Fracture Toughness of Hot‐Pressed Silicon Nitride Beam SpecimensJournal of the American Ceramic Society, 1996
- Super-Tough Silicon Nitride with R-Curve Behavior1989
- Back-Face Strain as a Method for Monitoring Stable Crack Extension1988
- Theory of Fatigue for Brittle Flaws Originating from Residual Stress ConcentrationsJournal of the American Ceramic Society, 1983
- Fracture from Controlled Surface Flaws1979
- Variability in Fatigue Crack Growth Rate TestingJournal of Testing and Evaluation, 1975