Ignition Control by DME-Reformed Gas in HCCI Combustion of DME
Authors:
- 19 May 2003
- conference paper
- Published by SAE International in SAE International Journal of Advances and Current Practices in Mobility
- Vol. 1
Abstract
Homogeneous charge compression ignition (HCCI) combustion enables higher thermal efficiency and lower NOx emission to be achieved in internal combustion engines compared with conventional combustion systems. Adjusting the proportion oftwo fuels with different ignition properties is an effective technique for controlling ignition timing in HCCI combustion. The authors have proposed a new HCCI combustion engine system fueled with dimethyl ether (DME) with a high cetane number and methanol-reformed gas (MRG) with a low cetane number in previous research. In the system, both DME and MRG are to be produced from methanol by onboard reformers utilizing exhaust heat from the engine. The research has shown high thermal efficiency of the system over a wide operable range of equivalence ratio. MRG effectively controls the timing of the second stage heat release by the high temperature reactions in HCCI of DME to expand operable range of equivalence ratio and engine load. This research newly proposes an HCCI combustion engine system fueled with DME and DME-reformed gas (DRG). In the system, just DME is stored in a fuel tank, and the DRG is to be produced by an onboard reformer utilizing exhaust heat from the engine. The system has an advantage of using the less toxic fuel over using methanol, though the heat recovery effect is lower than the previous system with MRG and DME produced from methanol. This research analyzes characteristics of HCCI combustion of DME and two types of DME-reformed gases. One type is a reformed gas by partial oxidation, and the other is by steam reforming. Both reformed gases contain hydrogen and carbon monoxide with low cetane numbers. The experiments are conducted by varying the proportion of the fuels and equivalence ratio. The overall thermal efficiency based on DME was also analyzed for ideal reforming conditions.Keywords
This publication has 9 references indexed in Scilit:
- The Effect of POx on the Autoignition Chemistry of n-Heptane and Isooctane in an HCCI EngineSAE International Journal of Advances and Current Practices in Mobility, 2002
- Influence of Hydrogen and Carbon Monoxide on HCCI Combustion of Dimethyl EtherSAE International Journal of Advances and Current Practices in Mobility, 2002
- HCCI Combustion of Hydrogen, Carbon Monoxide and Dimethyl EtherSAE International Journal of Advances and Current Practices in Mobility, 2002
- Analysis of Degree of Constant Volume and Cooling Loss in a Hydrogen Fuelled SI EngineSAE International Journal of Advances and Current Practices in Mobility, 2001
- Combustion Characteristics of H2-CO-CO2 Mixture in an IC EngineSAE International Journal of Advances and Current Practices in Mobility, 2001
- Analysis of the degree of constant volume and cooling loss in a spark ignition engine fuelled with hydrogenInternational Journal of Engine Research, 2001
- Numerical Calculation of the Ignition and the Combustion in Homogeneous Charge Compression Ignition Engine by using an Elementary Reaction Model in Case of Dimethyl Ether.TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series B, 2001
- Numerical Calculation of the Homogeneous Charge Compression Ignition Process by using an Elementary Reaction Model of Dimethyl Ether.TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series B, 2001
- Thermodynamik der Verbrennungskraftmaschine1939