Orientation Dependence of High Temperature Compressive Behavior of Textured Ti3SiC2
Authors:
Open Access
- 1 July 2024
- journal article
- research article
- Published by Japan Institute of Metals in Journal of the Japan Institute of Metals and Materials
- Vol. 88 (7) , 129-136
Abstract
In order to clarify the orientation dependent deformation behavior of the MAX phase ceramics, compressive deformation behavior was examined in a textured Ti3SiC2 (TSC) at a high temperature of 1200℃. Depending on the relationship between the texture and loading directions, both the deformation behavior and microstructure were strongly influenced, and the resultant basal slip, kink formation and delamination affected the compression behavior of the textured TSC. When the stress was loaded parallel or perpendicular to the basal plane (0TSC and 90TSC), the stress-strain (S-S) curves showed higher peak stresses followed by the reduction in the flow stress. When the stress was loaded 45° to the basal plane (45TSC), the S-S curve showed strain hardening after yielding, but did not show peak stress. Although the strength was higher both in 0TSC and 90TSC than in 45TSC, both 0TSC and 90TSC showed the formation of cracks and delamination, resulting to the large drop in the flow stress. In contrast to 0TSC and 90TSC, although 45TSC did not exhibit the peak stress, it exhibited work hardening due to the kink boundary formation, irrespective of the formation of delamination. It is reasonable to conclude from the deformation behavior and the deformed microstructures that for the TSC, the kink boundary plays an important role for attaining both deformability and strength. Mater. Trans. 64 (2023) 805-812に掲載Keywords
This publication has 37 references indexed in Scilit:
- The temperature effect on the plastic deformation of the Mg88Zn7Y5 alloy with LPSO phase studied by in-situ synchrotron radiation diffractionIntermetallics, 2021
- Intrinsic kink bands strengthening induced by several wrought-processes in Mg-Y-Zn alloys containing LPSO phaseMaterials Characterization, 2021
- Strengthening mechanisms acting in extruded Mg-based long-period stacking ordered (LPSO)-phase alloysActa Materialia, 2019
- Anisotropic plastic deformation of single crystals of the MAX phase compound Ti3SiC2 investigated by micropillar compressionActa Materialia, 2018
- Configuration of dislocations in low-angle kink boundaries formed in a single crystalline long-period stacking ordered Mg-Zn-Y alloyActa Materialia, 2018
- Orientation dependence of the deformation kink band formation behavior in Zn single crystalInternational Journal of Plasticity, 2016
- Crystallographic classification of kink bands in an extruded Mg–Zn–Y alloy using intragranular misorientation axis analysisActa Materialia, 2013
- New phases’ discovery in MAX familyInternational Journal of Refractory Metals and Hard Materials, 2013
- Dislocations, kink bands, and room-temperature plasticity of Ti3SiC2Metallurgical and Materials Transactions A, 1999
- Structure and nature of kink bands in zincJOM, 1949