Integrated feature scale modeling of plasma processing of porous and solid SiO2. I. Fluorocarbon etching
Authors:
- 1 July 2004
- journal article
- Published by American Vacuum Society in Journal of Vacuum Science & Technology A
- Vol. 22 (4) , 1242-1259
Abstract
Increases in RC delay times in interconnect wiring for microelectronics as feature sizes decrease have motivated investigations into the use of low-dielectric constant insulators, and in particular, porous silicon-dioxide (PS). Profile evolution and maintenance of critical dimensions during plasma etching of PS are problematic due to the exposure of open pores. To investigate these issues, reaction mechanisms for fluorocarbon plasma etching of SiO2 in C2F6, CHF3, and C4F8 chemistries have been developed and incorporated into the Monte Carlo Feature Profile Model which was modified to address these two-phase systems. The reaction mechanism was validated by comparison to experiments by others for etching of PS and solid SiO2 (SS). We found that the etch rates for PS are generally higher than that of SS due to the inherently lower mass fraction. Mass corrected etch rates of PS can be larger or smaller than those for SS depending on the degree of pore filling by polymer and the degree of ion activated chemical sputtering. Pore filling is particularly important for PS having open networks with large pores and high porosities. We found little dependence of the taper of high aspect ratio profiles on the average pore radius and porosity. However, the profile changes from tapered to bowed as the interconnectivity of the porous network increases. Scaling laws for profile shapes are otherwise similar for both SS and PS.Keywords
This publication has 39 references indexed in Scilit:
- Analysis of SiO2-to-Si3N4 selectivity in reactive ion etching using additional O2 gasJournal of Vacuum Science & Technology A, 2002
- Etch mechanisms of low dielectric constant polymers in high density plasmas: Impact of charging effects on profile distortion during the etching processJournal of Vacuum Science & Technology B: Microelectronics and Nanometer Structures Processing, Measurement, and Phenomena, 2001
- Modeling the plasma chemistry of C2F6 and CHF3 etching of silicon dioxide, with comparisons to etch rate and diagnostic dataJournal of Vacuum Science & Technology A, 2001
- High density plasma etching of low k dielectric polymers in oxygen-based chemistriesJournal of Vacuum Science & Technology B: Microelectronics and Nanometer Structures Processing, Measurement, and Phenomena, 2001
- High-density plasma patterning of low dielectric constant polymers: A comparison between polytetrafluoroethylene, parylene-N, and poly(arylene ether)Journal of Vacuum Science & Technology A, 2001
- Effects of H2 Addition in Magnetized Inductively Coupled C2F6 Plasma Etching of Silica Aerogel FilmJapanese Journal of Applied Physics, 2000
- Determination of pore size distribution in thin films by ellipsometric porosimetryJournal of Vacuum Science & Technology B: Microelectronics and Nanometer Structures Processing, Measurement, and Phenomena, 2000
- Determination of pore-size distribution in low-dielectric thin filmsApplied Physics Letters, 2000
- Properties of nanoporous silica thin films determined by high-resolution x-ray reflectivity and small-angle neutron scatteringJournal of Applied Physics, 2000
- Positronium annihilation in mesoporous thin filmsPhysical Review B, 1999