Stress Corrosion Cracking of 304L Austenitic Steel and the Martensite Transformation
Authors:
- S. S. BirleySBS. S. Birley
- 1 February 1971
- journal article
- Published by Association for Materials Protection and Performance (AMPP) in Corrosion
- Vol. 27 (2) , 63-71
Abstract
Studies have been conducted on the failure of notched and annealed rods of 304L austenitic steel stressed in tension in an aqueous solution of MgCl2 boiling at 154 C (309 F). The phases present on the actual fracture surfaces were studied by electron diffraction techniques. Martensite etching techniques were used to detect the presence of martensite phases adjacent to stress corrosion cracks and to relate stress corrosion crack topography with the morphology of martensite formation. The observations were consistent with a mechanism of stress corrosion cracking involving formation of b.c.c. α′ -phase adjacent to the crack tip and subsequent propagation of the crack through this phase. The possible mechanism by which α′-phase is formed and the possible mechanism of crack propagation through the α′-phase are both discussed.Keywords
This publication has 10 references indexed in Scilit:
- The martensite phases in 304 stainless steelMetallurgical Transactions, 1970
- A Technical Note: Stress Corrosion Cracking of Austenitic Stainless SteelCorrosion, 1970
- Mechanism of Chloride Stress Corrosion Cracking of Austenitic Stainless SteelsCorrosion, 1969
- Hydrogen-Induced Phase Transformations in Type 304L Stainless SteelsCorrosion, 1968
- The martensite transformation in steels with low stacking fault energyActa Metallurgica, 1965
- Hydrogen Embrittlement of Austenitic Stainless SteelCorrosion, 1965
- I. Nature of Initial Corrosion Of Stressed Austenitic Stainless Steel by Chloride IonsCorrosion, 1964
- The spontaneous martensitic transformations in 18% Cr, 8% Ni steelsActa Metallurgica, 1962
- Mechanical metallurgy.1961
- The formation of stacking faults in austenite and its relation to martensiteActa Metallurgica, 1957