Development of a Low Temperature Sinterable Cu Paste Based on Micro Scale Flakes
Authors:
- 27 May 2025
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1247-1254
Abstract
New generation power electronic (PE) modules require die attach materials, that can withstand high operational temperatures exceeding 175°C, as well as extreme thermo-mechanical stress conditions spanning from +150 °C to -40 °C. Copper (Cu) sintering is widely considered an advanced interconnection technology to meet such criterion. However, the higher melting point of Cu directly translates into a higher sintering temperature, which is undesirable, especially due to the thermo-mechanical stresses that build up in the assembly after the sintering process. In this paper, low temperature sintering behavior of three different pastes are investigated: A) paste with coated copper flakes, B) paste using non coated copper flakes, C) coper flake based paste with complexed copper formate (Cuprum SIC from CuNex GmbH). Two-step sintering methods are applied, i.e. after printing, the paste is pre-dried before sintering under pressure. Pressure-assisted sintering experiments are performed with different temperature and time. A high shear strength of~ 50 MPa could be achieved at 250°C under inert atmosphere, even while sintering for just 1 minute with bonding pressure of 20 MPa. The microstructure of the interconnects is investigated by scanning electron microscopy performed on Ar ion-beam milled cross-sections. Scanning acoustic microscopy is performed to ascertain the quality of the sintered interconnects.Keywords
This publication has 29 references indexed in Scilit:
- Hybrid Cu sinter paste for low temperature bonding of bare semiconductorsMaterials Letters, 2024
- Comparing the mechanical and thermal-electrical properties of sintered copper (Cu) and sintered silver (Ag) jointsJournal of Alloys and Compounds, 2021
- Characterization of the die-attach process via low-temperature reduction of Cu formate in airJournal of Materials Science: Materials in Electronics, 2019
- Transient Liquid Phase Bonding2019
- A Brief Review on High-Temperature, Pb-Free Die-Attach MaterialsJournal of Electronic Materials, 2018
- Emerging trends in wide band gap semiconductors (SiC and GaN) technology for power devicesMicroelectronic Engineering, 2018
- Reactive and liquid-phase sintering techniques2018
- Pressureless sintering bonding using hybrid microscale Cu particle paste on ENIG, pure Cu and pre-oxidized Cu substrate by an oxidation–reduction processJournal of Materials Science: Materials in Electronics, 2016
- One-step green synthesis of cuprous oxide crystals with truncated octahedra shapes via a high pressure flux approachJournal of Solid State Chemistry, 2011
- A Review on Die Attach Materials for SiC-Based High-Temperature Power DevicesMetallurgical and Materials Transactions B, 2010