Machine Tool Chatter and Surface Location Error in Milling Processes
- 8 March 2006
- journal article
- Published by ASME International in Journal of Manufacturing Science and Engineering
- Vol. 128 (4) , 913-920
Abstract
A two degree of freedom model of the milling process is investigated. The governing equation of motion is decomposed into two parts: an ordinary differential equation describing the periodic chatter-free motion of the tool and a delay-differential equation describing chatter. The stability chart is derived by using the semi-discretization method for the delay-differential equation corresponding to the chatter motion. The periodic chatter-free motion of the tool and the associated surface location error (SLE) are obtained by a conventional solution technique of ordinary differential equations. It is shown that the SLE is large at the spindle speeds where the ratio of the dominant frequency of the tool and the tooth passing frequency is an integer. This phenomenon is explained by the large amplitude of the periodic chatter-free motion of the tool at these resonant spindle speeds. It is shown that large stable depths of cut with a small SLE can still be attained close to the resonant spindle speeds by using the SLE diagrams associated with stability charts. The results are confirmed experimentally on a high-speed milling center.Keywords
This publication has 38 references indexed in Scilit:
- Stability limits of milling considering the flexibility of the workpiece and the machineInternational Journal of Machine Tools and Manufacture, 2005
- Impact of the cutting dynamics of small radial immersion milling operations on machined surface roughnessInternational Journal of Machine Tools and Manufacture, 2004
- Structural modeling of end mills for form error and stability analysisInternational Journal of Machine Tools and Manufacture, 2004
- Mechanistic identification of specific force coefficients for a general end millInternational Journal of Machine Tools and Manufacture, 2004
- Prediction of regenerative chatter by modelling and analysis of high-speed millingInternational Journal of Machine Tools and Manufacture, 2003
- Simulation and experimental investigation of the end milling process considering the cutter flexibilityInternational Journal of Machine Tools and Manufacture, 2003
- Stability of up-milling and down-milling, part 1: alternative analytical methodsInternational Journal of Machine Tools and Manufacture, 2003
- Modelling and simulation of chatter in milling using a predictive force modelInternational Journal of Machine Tools and Manufacture, 2000
- ANALYTICAL MODELING OF FORCE SYSTEM IN BALL-END MILLINGMachining Science and Technology, 1997
- Cutting force and dimensional surface error generation in peripheral milling with variable pitch helical end millsInternational Journal of Machine Tools and Manufacture, 1996