Optimization of HiPIMS discharges: The selection of pulse power, pulse length, gas pressure, and magnetic field strength
Open Access
- 17 April 2020
- journal article
- research article
- Published by American Vacuum Society in Journal of Vacuum Science & Technology A
- Vol. 38 (3) , 033008
Abstract
In high power impulse magnetron sputtering (HiPIMS) operation, there are basically two goals: a high ionized flux fraction of the sputtered target material and a high deposition rate. In this work, it is demonstrated that the former always comes at the cost of the latter. This makes a choice necessary, referred to as the HiPIMS compromise. It is here proposed that this compromise is most easily made by varying the discharge current amplitude, which opens up for optimization of additionally four external process parameters: the pulse length, the working gas pressure, the magnetic field strength, and the degree of magnetic unbalance to achieve the optimum combination of the ionized flux fraction and the deposition rate. As a figure of merit, useful for comparing different discharges, (1−βt) is identified, which is the fraction of ionized sputtered material that escapes back-attraction toward the cathode target. It is shown that a discharge with a higher value of (1−βt) always can be arranged to give better combinations of ionization and deposition rate than a discharge with a lower (1−βt). Maximization of (1−βt) is carried out empirically, based on data from two discharges with Ti targets in Ar working gas. These discharges were first modeled in order to convert measured plasma parameters to values of (1−βt). The combined effects of varying the different process parameters were then analyzed using a process flow chart model. The effect of varying the degree of unbalance in the studied range was small. For the remaining three parameters, it is found that optimum is achieved by minimizing the magnetic field strength, minimizing the working gas pressure, and minimizing the pulse length as far as compatible with the requirement to ignite and maintain a stable discharge.Keywords
Funding Information
- Swedish Goverment Strategic Research Area in Materials Science (2009-00971)
- Free State of Saxony and the European Regional Development Fund (100336119)
- Swedish Research Council (2018-04139)
- Icelandic Icelandic Research Fund (130029)
- Icelandic Icelandic Research Fund (1961141)
This publication has 45 references indexed in Scilit:
- An ionization region model for high-power impulse magnetron sputtering dischargesPlasma Sources Science and Technology, 2011
- A phenomenological equilibrium model applicable to high-power pulsed magnetron sputteringPlasma Sources Science and Technology, 2010
- On the film density using high power impulse magnetron sputteringSurface and Coatings Technology, 2010
- Fully dense, non-faceted 111-textured high power impulse magnetron sputtering TiN films grown in the absence of substrate heating and biasThin Solid Films, 2010
- The evolution of the plasma potential in a HiPIMS discharge and its relationship to deposition ratePlasma Sources Science and Technology, 2010
- Phase tailoring of Ta thin films by highly ionized pulsed magnetron sputteringThin Solid Films, 2007
- Ionized physical vapor deposition (IPVD): A review of technology and applicationsThin Solid Films, 2006
- A novel pulsed magnetron sputter technique utilizing very high target power densitiesSurface and Coatings Technology, 1999
- Metal ion deposition from ionized mangetron sputtering dischargeJournal of Vacuum Science & Technology B: Microelectronics and Nanometer Structures Processing, Measurement, and Phenomena, 1994
- Magnetron sputter deposition with high levels of metal ionizationApplied Physics Letters, 1993