Influence of Duration of the Conditioning Process on the Reduction of Case-Hardening Level in Kiln-Dried Beech and Oak Lumber
Authors:
- 11 September 2008
- journal article
- research article
- Published by Taylor & Francis in Drying Technology
- Vol. 26 (10) , 1225-1231
Abstract
The research results from an analysis of the influence of conditioning time on case-hardening reduction are presented. The levels of case-hardening and moisture content differences across the thickness on beech and oak lumber were measured before, during, and after conditioning. A relationship between gap, as the measure of case-hardening in wood (ENV 14464), and conditioning time was found; a highly linear relationship also exists between gap and moisture content differences across the lumber thickness. Time analysis showed that much shorter conditioning times were adequate to reach acceptable drying quality than the times currently used. It is shown that the conditioning regimes that use equilibrium moisture content lower than the final moisture content are inadequate to obtain a dried product quality that meets modern European standards.Keywords
This publication has 7 references indexed in Scilit:
- Non-destructive Measurement of Moisture Distribution in Wood during Drying Using Digital X-ray MicroscopyDrying Technology, 2008
- Moisture content distribution across thickness of kiln dried oak and beech lumber during conditioning phaseEuropean Journal of Wood and Wood Products, 2007
- Energy Saving in Industrial Wood Drying Addressed by a Multiscale Computational Model: Board, Stack, and KilnDrying Technology, 2007
- Opportunities to Reduce Energy Consumption in Softwood Lumber DryingDrying Technology, 2006
- A Physical and Mechanical Model Able to Predict the Stress Field in Wood over a Wide Range of Drying ConditionsDrying Technology, 2004
- ANALYSIS AND OPTIMIZATION OF THE CONDITIONING PHASE IN TIMBER DRYINGDrying Technology, 2001
- Prediction of required duration of the conditioning process to reduce the casehardening level in LT-dried sawn timber - Initial experimentsEuropean Journal of Wood and Wood Products, 2001