Effect of solution treatment on the fatigue behavior of an as-forged Mg-Zn-Y-Zr alloy
Open Access
- 1 April 2016
- journal article
- research article
- Published by Springer Nature in Scientific Reports
- Vol. 6 (1) , 23955
Abstract
Through investigating and comparing the fatigue behavior of an as-forged Mg-6.7Zn-1.3Y-0.6Zr (wt.%) alloy before and after solid solution treatment (T4) in laboratory air, the effect of T4 treatment on fatigue crack initiation was disclosed. S-N curves illustrated that the fatigue strength of as-forged samples was 110 MPa, whereas the fatigue strength of T4 samples was only 80 MPa. Observations to fracture surfaces demonstrated that for as-forged samples, fatigue crack initiation sites were covered with a layer of oxide film. However, due to the coarse grain structure and the dissolution of MgZn2 precipitates, the activation and accumulation of {10–12} twins in T4 samples were much easier, resulting in the preferential fatigue crack initiation at cracked twin boundaries (TBs). Surface characterization demonstrated that TB cracking was mainly ascribed to the incompatible plastic deformation in the twinned area and nearby α-Mg matrix.Keywords
This publication has 34 references indexed in Scilit:
- Relationship between fatigue crack initiation and activated twins in as-extruded pure magnesiumScripta Materialia, 2013
- Cyclic slip irreversibility and fatigue life: A microstructure-based analysisActa Materialia, 2013
- Effects of icosahedral phase formation on the microstructure and mechanical improvement of Mg alloys: A reviewProgress in Natural Science: Materials International, 2012
- Temperature dependency of slip and twinning in plane strain compressed magnesium single crystalsActa Materialia, 2011
- A comparative study of high resolution cone beam X-ray tomography and synchrotron tomography applied to Fe- and Al-alloysNDT & E International, 2010
- A model for slip irreversibility, and its effect on the fatigue crack propagation threshold in a nickel-base superalloyActa Materialia, 2005
- Microstructures and textures of pure magnesium deformed in plane-strain compressionScripta Materialia, 2004
- Influence of grain size on the compressive deformation of wrought Mg–3Al–1ZnActa Materialia, 2004
- The activity of non-basal slip systems and dynamic recovery at room temperature in fine-grained AZ31B magnesium alloysActa Materialia, 2003
- Application of ultrasound for fatigue testing of lightweight alloysFatigue & Fracture of Engineering Materials & Structures, 1999