Physically Based Estimation of Bare-Surface Soil Moisture With the Passive Radiometers
Authors:
- J. ShiJSJ. Shi
- L. JiangLJL. Jiang
- L. ZhangLZL. Zhang
- K.S. ChenKCK.S. Chen
- J.P. WigneronJ.P. Wigneron
- A. ChanzyACA. Chanzy
- T.J. JacksonTJT.J. Jackson
- 30 October 2006
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Geoscience and Remote Sensing
- Vol. 44 (11) , 3145-3153
Abstract
A physically based bare-surface soil moisture inversion technique for application with passive microwave satellite measurements, including the Advanced Microwave-Scanning Radiometer-Earth Observing System, Special Sensor Microwave/Imager, Scanning Multichannel Microwave Radiometer, and Tropical Rainfall Measuring Mission Microwave Imager, was developed in this paper. The inversion technique is based on the concept of a simple parameterized surface emission model, the Qp model, which was developed using advanced integral equation model simulations of microwave emission. Through evaluation of the relationship between roughness parameters Qp at different polarizations, it was found that they could be described by a linear function. Using this relationship and the surface emissivities measured from two polarizations, the effect of the surface roughness is cancelled out. In other words, this approach consisted in adding different weights on the v and h polarization measurements so as to minimize the surface roughness effects. This method leads to a dual-polarization inversion technique for the estimation of the surface dielectric properties directly from the emissivity measurements. For validation, we compared the soil moisture estimates, derived from ground radiometer measurements at C- to Ka-band obtained from the Institute National de Recherches Agronomiques' field experimental data in 1993 and the Beltsville Agricultural Research Center's field experimental data at C- and X-band obtained in 1979-1982, with the field in situ soil moisture measurements. The accuracies [root-mean-square error (rmse)] are higher than 4% for the available experimental data at the incidence angles of 50deg and 60deg. The newly developed inversion technique should be very useful in monitoring global soil moisture properties using the currently available satellite instruments that commonly have incidence angles between 50deg and 55degKeywords
This publication has 17 references indexed in Scilit:
- A parameterized multifrequency-polarization surface emission modelIEEE Transactions on Geoscience and Remote Sensing, 2005
- Emission of rough surfaces calculated by the integral equation method with comparison to three-dimensional moment method simulationsIEEE Transactions on Geoscience and Remote Sensing, 2003
- A simple parameterization of the L-band microwave emission from rough agricultural soilsIEEE Transactions on Geoscience and Remote Sensing, 2001
- Frequency and angular variations of land surface microwave emissivities: can we estimate SSM/T and AMSU emissivities from SSM/I emissivities?IEEE Transactions on Geoscience and Remote Sensing, 2000
- Rough bare soil reflectivity modelIEEE Transactions on Geoscience and Remote Sensing, 1999
- Soil moisture mapping at regional scales using microwave radiometry: the Southern Great Plains Hydrology ExperimentIEEE Transactions on Geoscience and Remote Sensing, 1999
- Mapping surface soil moisture using an aircraft-based passive microwave instrument: algorithm and exampleJournal of Hydrology, 1996
- Calculations of the Microwave Brightness Temperature of Rough Soil Surfaces: Bare FieldIEEE Transactions on Geoscience and Remote Sensing, 1987
- Multifrequency Measurements of the Effects of Soil Moisture, Soil Texture, And Surface RoughnessIEEE Transactions on Geoscience and Remote Sensing, 1983
- Remote sensing of soil moisture content, over bare field at 1.4 GHz frequencyJournal of Geophysical Research: Oceans, 1981