In situ x-ray observation of bainitic transformation of austempered silicon alloyed steel
- 1 April 2009
- journal article
- Published by Springer Nature in Journal of Materials Research
- Vol. 24 (4) , 1559-1566
Abstract
The in situ x-ray diffraction observations of the bainitic transformation were conducted by using the high-temperature x-ray diffraction technique. The volume fraction and carbon content of austenite depend on the transformation temperature. The d{110} value of bainitic ferrite decreases with increasing austempering temperature, which is related to the decrease of carbon concentration in bainitic ferrite. Asymmetry diffraction peaks are obtained for samples at the early stage of transformation at any austempering temperatures. This asymmetry diffraction peak after the formation of bainitic ferrite could be attributed to a heterogeneous distribution of carbon in different regions of austenite and show that two types of austenite with different carbon contents, low-carbon austenite (γLC) and the high-carbon austenite (γHC), exist during the transformation. The microstructure after cooling down to room temperature is presented to show the effectiveness of the x-ray diffraction analysis.Keywords
This publication has 17 references indexed in Scilit:
- Synchrotron X-ray studies of austenite and bainitic ferriteProceedings of the Royal Society A: Mathematical, Physical and Engineering Sciences, 2008
- Fracture toughness improvement of austempered high silicon steel by titanium, vanadium and rare earth elements modificationMaterials Science and Engineering: A, 2007
- In-situ observations of lattice parameter fluctuations in austenite and transformation to bainiteMetallurgical and Materials Transactions A, 2005
- Influence of austempering temperature on microstructure and fracture toughness of a high-carbon, high-silicon and high-manganese cast steelMaterials & Design (1980-2015), 2003
- Effect of isothermal transformation temperature on amount of retained austenite and its thermal stability in a bainitic Fe–3%Si–0.45%C–X steelScripta Materialia, 2002
- AUSTEMPERING OF A SILICON MANGANESE CAST STEELMaterials and Manufacturing Processes, 2002
- Microstructure and mechanical properties of austempered high silicon cast steelMaterials Science and Engineering: A, 2001
- Design of novel high strength bainitic steels: Part 2Materials Science and Technology, 2001
- Fracture toughness of a high carbon and high silicon steelMaterials Science and Engineering: A, 2001
- Analysis of mechanical properties and microstructure of high-silicon dual-phase steelMetal Science, 1980