Realizing High Thermoelectric Performance of Bi-Sb-Te-Based Printed Films through Grain Interface Modification by an In Situ-Grown β-Cu2-δSe Phase
Open Access
- 15 December 2021
- journal article
- research article
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 13 (51) , 61386-61395
Abstract
It has been a substantial challenge to develop a printed thermoelectric (TE) material with a figure-of-merit ZT > 1. In this work, high ZT p-type Bi0.5Sb1.5Te3-based printable TE materials have been advanced by interface modification of the TE grains with a nonstoichiometric β-Cu2-δSe-based inorganic binder (IB) through a facile printing–sintering process. As a result, a very high TE power factor of ∼17.5 μW cm–1 K–2 for a p-type printed material is attained in the optimized compounds at room temperature (RT). In addition, a high ZT of ∼1.2 at RT and of ∼1.55 at 360 K is realized using thermal conductivity (κ) of a pellet made of the prepared printable material containing 10 wt % of IB. Using the same material for p-type TE legs and silver paste for n-type TE legs, a printed TE generator (print-TEG) of four thermocouples has been fabricated for demonstration. An open-circuit voltage (VOC) of 14 mV and a maximum power output (Pmax) of 1.7 μW are achieved for ΔT = 40 K for the print-TEG.Keywords
Funding Information
- Deutsche Bundesstiftung Umwelt
- Deutsche Forschungsgemeinschaft (EXC-2082/1 390761711)
- Ministerium f??r Wissenschaft, Forschung und Kunst Baden-W??rttemberg
This publication has 42 references indexed in Scilit:
- Hybrid composite of screen-printed inorganic thermoelectric film and organic conducting polymer for flexible thermoelectric power generatorEnergy, 2014
- Thermoelectric properties of P-type Sb2Te3 thick film processed by a screen-printing technique and a subsequent annealing processJournal of Alloys and Compounds, 2014
- Engineered doping of organic semiconductors for enhanced thermoelectric efficiencyNature Materials, 2013
- Improvement of thermoelectric properties of screen-printed Bi2Te3 thick film by optimization of the annealing processJournal of Alloys and Compounds, 2013
- Problems of designing radioisotope thermoelectric power generators with a service life of decades for use in outer space exploration vehiclesThermal Engineering, 2012
- Organic Thermoelectric Materials and Devices Based on p‐ and n‐Type Poly(metal 1,1,2,2‐ethenetetrathiolate)sAdvanced Materials, 2012
- Optimization of the thermoelectric figure of merit in the conducting polymer poly(3,4-ethylenedioxythiophene)Nature Materials, 2011
- Complex thermoelectric materialsNature Materials, 2008
- Clustering of randomly placed spheresBiometrika, 1972
- Percolation in Heavily Doped SemiconductorsPhysical Review B, 1969