Collision Characteristics During Autonomous Underwater Vehicle Recovery with a Petal Mechanical Gripper
Open Access
- 5 March 2025
- journal article
- research article
- Published by MDPI AG in Journal of Marine Science and Engineering
- Vol. 13 (3) , 504
Abstract
Efficient underwater recovery systems are essential for battery recharging and data exchange of autonomous underwater vehicles (AUVs). This paper introduced a petal mechanical gripper (PMG) for AUV underwater recovery, and investigated the collision characteristics between the AUV and PMG during the recovery. A collision model was developed with Adams software 2018 to investigate the effect of the recovery mode and closure speed of a PMG driving claw on the recovery efficiency and AUV motion behaviors. A tank experiment was performed to validate the collision model. The simulation results indicated that the active recovery mode had a higher efficiency. Moreover, optimizing the PMG closure speed significantly reduced the recovery time and improved the AUV motion stability. This study provides valuable theoretical guidance for the effective recovery of underwater vehicles.Keywords
Funding Information
- National Natural Science Foundation of China (52375024, 2021CXGC010708)
- Key R&D Program of Shandong Province, China (52375024, 2021CXGC010708)
This publication has 21 references indexed in Scilit:
- Seal-Inspired Underwater Glider With a Rigid-Flexible Composite HullIEEE Journal of Oceanic Engineering, 2023
- Estimation of hydrodynamic coefficients and simplification of the depth model of an AUV using CFD and sensitivity analysisOcean Engineering, 2022
- A physics-based simulation for AUV underwater docking using the MHDG method and a discretized propellerOcean Engineering, 2019
- Study on dynamic characteristics analysis of underwater dynamic docking deviceOcean Engineering, 2019
- Study on impact process of AUV underwater docking with a cone-shaped dockOcean Engineering, 2017
- A Concept for Docking a UUV With a Slowly Moving Submarine Under WavesIEEE Journal of Oceanic Engineering, 2015
- Hydrodynamic analysis of AUV underwater docking with a cone-shaped dock under ocean currentsOcean Engineering, 2014
- DYNAMICS OF TWO ACTIVE AUTONOMOUS DOCK MECHANISMS FOR AUV RECOVERYTransactions of the Canadian Society for Mechanical Engineering, 2014
- Docking Control System for a 54-cm-Diameter (21-in) AUVIEEE Journal of Oceanic Engineering, 2008
- Enabling technologies for REMUS docking: an integral component of an autonomous ocean-sampling networkIEEE Journal of Oceanic Engineering, 2001