Highly Sensitive and Selective Acetylene CuO/ZnO Heterostructure Sensors through Electrospinning at Lean O2 Concentration for Transformer Diagnosis
- 2 January 2024
- journal article
- research article
- Published by American Chemical Society (ACS) in ACS Sensors
- Vol. 9 (1) , 217-227
Abstract
Acetylene (C2H2) is a gas that can cause explosions in transformers even at low concentrations. Gas chromatography (GC) or photoacoustic spectroscopy (PAS) have been used to detect C2H2 during dissolved gas analysis (DGA), but they are not suitable for monitoring numerous transformers at substations. Even though metal oxide semiconductor (MOS) based C2H2 sensors have drawn much attention as a potential solution, existing MOS-based C2H2 sensors have low sensitivity toward C2H2 in the transformer environment (10 h). In addition, the CZ2 sensor also shows a high selectivity (>5 times) to coexisting transformer oil gases which are H2, CH4, C2H4, C2H6, CO, and CO2. Overall, this study is the first to demonstrate a high performing DGA sensor under 2% O2 concentration that can provide a practical solution to monitoring the low concentration of C2H2 in transformers effectively.Keywords
Funding Information
- KEPCO Research Institute (R23XA01)
- Korea Technology and Information Promotion Agency for SMEs (RS-2022-00165292)
- Korea Evaluation Institute of Industrial Technology (RS-2022-00154820)
This publication has 45 references indexed in Scilit:
- C2H2 gas sensor based on Ni-doped ZnO electrospun nanofibersCeramics International, 2013
- A review of sensor-based methods for monitoring hydrogen sulfideTrAC Trends in Analytical Chemistry, 2012
- Hydrothermal synthesis of hierarchical nanoparticle-decorated ZnO microdisks and the structure-enhanced acetylene sensing properties at high temperaturesSensors and Actuators B: Chemical, 2011
- Acetylene sensor based on Pt/ZnO thick films as prepared by flame spray pyrolysisSensors and Actuators B: Chemical, 2011
- New Top-Down Approach for Fabricating High-Aspect-Ratio Complex Nanostructures with 10 nm Scale FeaturesNano Letters, 2010
- Direct formation of highly porous gas-sensing films by in situ thermophoretic deposition of flame-made Pt/SnO2 nanoparticlesSensors and Actuators B: Chemical, 2006
- Use of X-ray tomography to study the porosity and morphology of granulesPowder Technology, 2003
- A study of porosity and permeability using a lattice Boltzmann simulationGeophysical Research Letters, 1998
- Practical use of mercury porosimetry in the study of porous solidsPowder Technology, 1981
- Study of metal oxide catalysts by temperature programmed desorption. 4. Oxygen adsorption on various metal oxidesThe Journal of Physical Chemistry, 1978