Iron and Aluminium Production Wastes as Exclusive Components of Alkali Activated Binders—Towards a Sustainable Alternative
Open Access
- 4 September 2021
- journal article
- research article
- Published by MDPI AG in Sustainability
- Vol. 13 (17) , 9938
Abstract
The sustainability of resources is becoming a worldwide concern, including construction and building materials, especially with the alarming increase rate in global population. Alternative solutions to ordinary Portland cement (OPC) as a concrete binder are being studied, namely the so-called alkali-activated cements (AAC). These are less harmful to the environment, as lower CO2 emissions are associated with their fabrication, and their mechanical properties can be similar to those of the OPC. The aim of developing alkali-activated materials (AAM) is the maximization of the incorporated recycled materials, which minimises the CO2 emissions and cost, while also achieving acceptable properties for construction applications. Therefore, various efforts are being made to produce sustainable construction materials based on different sources and raw materials. Recently, significant attention has been raised from the by-products of the steelmaking industry, mostly due to their widespread availability. In this paper, ladle slag (LS) resulting from steelmaking operations was studied as the main precursor to produce AAC, combined with phosphating bath sludge—or phosphate sludge (PS)—and aluminium anodising sludge (AS), two by-products of the surface treatment of metals, in replacement rates of 10 and 20 wt.%. The precursors were activated by two different alkaline solutions: a combination of commercial sodium hydroxide and sodium silicate (COM), and a disposed solution from the cleaning of aluminium extrusion steel dies (CLE). This study assesses the influence of these by-products from the steelmaking industry (PS, AS and CLE) on the performance of the alkali-activated LS, and specifically on its fresh and hardened state properties, including rheology, heat of hydration, compressive strength and microstructure and mineralogy (X-ray diffraction, scanning electron microscopy coupled with energy dispersive spectroscopy and Fourier transform infra-red. The results showed that the CLE had no negative impact on the strength of the AAM incorporating PS or/and AS, while increasing the strength of the LS alone by 2×. Additionally, regardless of the precursor combination, the use of a commercial activator (COM) led to more fluid pastes, compared with the CLE.Keywords
Funding Information
- European Regional Development Fund (NORTE-01-0247-FEDER-017501)
This publication has 40 references indexed in Scilit:
- Effects of iron oxides on the rheological properties of cementitious slurryColloids and Surfaces A: Physicochemical and Engineering Aspects, 2014
- Properties of concrete containing ground granulated blast furnace slag (GGBFS) at elevated temperaturesJournal of Advanced Research, 2012
- Compatibility studies between N-A-S-H and C-A-S-H gels. Study in the ternary diagram Na2O–CaO–Al2O3–SiO2–H2OCement and Concrete Research, 2011
- Recovery of Phosphate Sludge as Concrete Supplementary MaterialCLEAN – Soil, Air, Water, 2010
- The utilization of recycled concrete aggregate to produce controlled low-strength materials without using Portland cementCement and Concrete Composites, 2009
- Influence of phosphate of the waste sludge on the hydration characteristics of eco-cementJournal of Hazardous Materials, 2009
- Alkali-activated binders: A review. Part 2. About materials and binders manufactureConstruction and Building Materials, 2008
- Sustainability of Concrete ConstructionPractice Periodical on Structural Design and Construction, 2008
- Properties of sintered mullite and cordierite pressed bodies manufactured using Al-rich anodising sludgeCeramics International, 2008
- The calcium silicate hydratesCement and Concrete Research, 2008