Effect of Spindle Speed and Feed Rate on Surface Roughness and Milling Duration in Fabrication of the Milled Complete Dentures: An In Vitro Study
Preprint
- 9 November 2023
- preprint
- Published by MDPI AG in Preprints.org
Abstract
Milling machines have made denture fabrication possible with high accuracy in a short time. However, the relationship between the milling conditions, accuracy, and milling duration has not been clarified. This study aimed to clarify the effects of milling conditions on surface roughness and milling duration. The specimen was designed using a CAD software, and milled using PMMA disks. In milling, the parameters of finishing the specimen surface were adjusted. Three different spindle speeds and four different feed rates were set. Twelve combinations of each parameter were used for milling, and the surface roughness and milling duration were measured. Results showed that the surface roughness significantly increased with the feed rate on the slopes of the specimen. The surface roughness differed with the spindle speed on the left and right slopes. The spindle speed and feed rate did not affect the surface roughness on the flat surface. The milling duration was not affected by spindle speed but decreased as the feed rate increased. In conclusion, by increasing both the spindle speed and feed rate, the milling duration could be shortened while maintaining a constant surface quality. The optimum milling conditions were a spindle speed of 40,000 rpm and feed rate of 3,500 mm/min.Keywords
All Related Versions
- Version 1, 2023-11-09, Preprints
- Published version: Applied Sciences, 13 (24), 13338.
This publication has 22 references indexed in Scilit:
- Patient-reported outcome and cost-effectiveness analysis of milled and conventionally fabricated complete dentures in a university clinic: A retrospective studyThe Journal of Prosthetic Dentistry, 2022
- CAD-CAM milled complete dentures with custom disks and prefabricated artificial teeth: A dental techniqueThe Journal of Prosthetic Dentistry, 2022
- CAD-CAM complete denture resins: an evaluation of biocompatibility, mechanical properties, and surface characteristicsJournal of Dentistry, 2021
- Single-arch digital removable complete denture: A workflow that starts from the intraoral scanThe Journal of Prosthetic Dentistry, 2018
- Optimization of machining parameters to improve the surface qualityProcedia Structural Integrity, 2017
- CAD/CAM milled removable complete dentures: an in vitro evaluation of truenessClinical Oral Investigations, 2016
- Comparison of denture base adaptation between CAD-CAM and conventional fabrication techniquesThe Journal of Prosthetic Dentistry, 2016
- CAD/CAM fabricated complete dentures: concepts and clinical methods of obtaining required morphological dataThe Journal of Prosthetic Dentistry, 2012
- The statistical modeling of surface roughness in high-speed flat end millingInternational Journal of Machine Tools and Manufacture, 2006
- Predicting surface roughness in machining: a reviewInternational Journal of Machine Tools and Manufacture, 2003