Entrapment of distilled palmarosa (cymbopogon martinii) wastes in alginate beads for adsorptive removal of methylene blue from aqueous solution
- 23 February 2018
- journal article
- research article
- Published by Wiley in Environmental Progress & Sustainable Energy
- Vol. 37 (6) , 1942-1953
Abstract
This study described a preparation of a low‐cost adsorbent by entrapment of palmarosa distillation wastes into alginate as supporting matrix and use of it for methylene blue (MB) dye removal from aqueous solution. Fourier transform infrared spectroscopy (FTIR) data of adsorbent confirms the entrapment for formation of composite beads. The effects of adsorption parameters (adsorbent dose, temperature, initial dye concentration, and pH) were investigated. Time to reach the equilibrium was dependent on dye concentration and it was 120 min for lower concentration and 240 min for higher concentration. The analysis of the kinetic data by pseudo‐first‐order and pseudo‐second‐order models displayed that MB adsorption followed pseudo‐second‐order model. The equilibrium data of MB adsorption were described by applying the Langmuir, Freundlich, and Temkin models. The observations from adsorption isotherms indicated that Langmuir model is the best fitted model and the maximum adsorption capacity (at the optimum pH 9.0) improved from 5.71 to 6.45 mg/g as the temperature increased from 298 to 328 K. The thermodynamic studies demonstrated that MB adsorption on to the adsorbent was spontaneous, feasible, and endothermic. Low desorption of the dyes from the adsorbent indicates that the dyes might have been chemisorbed on to the adsorbent surface. A single‐stage batch adsorber was designed and quantity of adsorbent required for treating 1–10 L of stained water was determined based on the Langmuir isotherm model equation. Results indicate that the composite bead could be an alternative for relatively costly adsorbents used for remediation of MB dye bearing industrial effluents. © 2018 American Institute of Chemical Engineers Environ Prog, 37: 1901–1907, 2018Keywords
This publication has 52 references indexed in Scilit:
- Adsorption studies of methylene blue onto activated saw dust: kinetics, equilibrium, and thermodynamic studiesEnvironmental Progress & Sustainable Energy, 2013
- Preparation and characterization of calcium alginate-based composite adsorbents for the removal of Cd, Hg, and Pb ions from aqueous solutionToxicological & Environmental Chemistry, 2012
- Study on Physico-Chemical Parameters of Waste Water Effluents from Taloja Industrial Area of Mumbai, IndiaInternational Journal of Ecosystem, 2011
- Batch adsorption of methylene blue from aqueous solution by garlic peel, an agricultural waste biomassJournal of Hazardous Materials, 2009
- Removal of basic dye (methylene blue) from wastewaters utilizing beer brewery wasteJournal of Hazardous Materials, 2008
- Characterization and utilization of mesoporous fertilizer plant waste carbon for adsorptive removal of dyes from aqueous solutionColloids and Surfaces A: Physicochemical and Engineering Aspects, 2006
- Biosorption of Pb(II) by Pleurotus ostreatus immobilized in calcium alginate gelProcess Biochemistry, 2005
- Solar/UV-induced photocatalytic degradation of three commercial textile dyesJournal of Hazardous Materials, 2002
- Pseudo-second order model for sorption processesProcess Biochemistry, 1999
- The heat of immersion of natural magnetite in aqueous solutionsThermochimica Acta, 1975