The effect of drill–pipe rotation on improving hole cleaning using polypropylene beads in water-based mud at different hole angles
Authors:
Open Access
- 5 December 2019
- journal article
- research article
- Published by Springer Nature in Journal of Petroleum Exploration and Production Technology
- Vol. 10 (3) , 1253-1262
Abstract
Hole cleaning is always a problem, particularly during drilling operations, and drilling fluid plays an important role in transporting drill cuttings through an annular section of wellbore to the surface. To transport the cuttings, a water-based mud with added polypropylene beads was selected since it is environmentally friendly and cost efficient. The polypropylene beads help to transport cuttings by providing an additional buoyancy force that lifts the cuttings to the surface via the influence of collision and drag forces. This experiment was performed using a 20 ft test section, 10 ppg drilling mud and 0.86 m/s annular velocity in a laboratory scale rig simulator, and the concentration of polypropylene beads was varied from 0 to 8 ppb. As the concentration of polypropylene increases, the cutting transport ratio also increases. It was observed that the fewest cuttings are lifted at a critical angle of 60°, followed by 45°, 30°, 90° and 0°. Additionally, cutting sizes had moderate effects on the cutting lifting efficiency, where smaller cutting sizes (0.5–1.0 mm) are easier to lift than larger cutting sizes (2.0–2.8 mm). Furthermore, a study of buoyancy force and impulsive force was conducted to investigate the cutting lifting efficiencies of various concentrations of polypropylene beads. This lifting capacity was also assisted by the presence of polyanionic cellulose (PAC), which increases the mud carrying capacity and is effective for smaller cuttings. The results show that in the presence of pipe rotation, the cutting lifting efficiency is slightly enhanced due to the orbital motion provided by the drill pipe for better hole cleaning. In conclusion, polypropylene beads combined with pipe rotation increase the cutting transport ratio in the wellbore.Keywords
Funding Information
- Centre for Teaching and Learning, Universiti Teknologi Malaysia (4F575)
This publication has 52 references indexed in Scilit:
- CFD Simulation of Rheological Model Effect on Cuttings TransportJournal of Dispersion Science and Technology, 2014
- Directional drilling in unstable environmentsInternational Journal of Mining Science and Technology, 2014
- Hole Cleaning Performance of Light-Weight Drilling Fluids During Horizontal Underbalanced DrillingJournal of Canadian Petroleum Technology, 2010
- Transport of Small Cuttings in Extended-Reach DrillingSPE Drilling & Completion, 2008
- Effect of Drillpipe Rotation on Hole Cleaning During Directional-Well DrillingSPE Journal, 1999
- Co-polymer Beads Reduce Friction In Horizontal WellsJournal of Canadian Petroleum Technology, 1996
- Model Aids Cuttings Transport PredictionJournal of Petroleum Technology, 1989
- Experimental Study of Drilled Cuttings Transport Using Common Drilling MudsSociety of Petroleum Engineers Journal, 1983
- Drill Cutting Transport in Full Scale Vertical AnnuliJournal of Petroleum Technology, 1974
- Carrying Capacity of Drilling MudsJournal of Petroleum Technology, 1951