Rheology of a New Sulfonic Associative Polymer in Porous Media
- 11 April 2011
- conference paper
- Published by Society of Petroleum Engineers (SPE)
Abstract
For hydrophobic associative polymers, incorporating a small fraction of hydrophobic monomer into an HP AM polymer can promote intermolecular associations and thereby enhance viscosities and resistance factors. In this paper, we investigate the behavior of a new associative polymer in porous media. The tetra-polymer has low hydrophobic monomer content and a molecular weight (Mw) of 12–17 million g/mol. Total anionic content is 15–25 mol%, including a few percent of a sulfonic monomer. This polymer is compared with a conventional HPAM with 18–20 million g/mol Mw and 35–40% anionic content. Rheological properties (viscosity versus concentration and shear rate, elastic and loss moduli versus frequency) were similar for the two polymers (in a 2.52% TDS brine at 25°C). For both polymers in cores with permeabilities from 300–13,000 md, no face plugging or internal filter cake formation was observed, and resistance factors correlated well using the capillary bundle parameter. For the HPAM polymer in these cores, low-flux resistance factors were consistent with low-shear-rate viscosities. In contrast, over the same permeability range, the associative polymer provided low-flux resistance factors that were 2–3 times the values expected from viscosities. Moderate shear degradation did not eliminate this effect—nor did flow through a few feet of porous rock. Propagation experiments in long cores (up to 157 cm) suggest that the unexpectedly high resistance factors could propagate deep into a reservoir—thereby providing enhanced displacement compared with conventional HPAM polymers. Compared with HPAM, the new polymer shows a significantly higher level of shear thinning at low fluxes and a lower degree of shear thickening at high fluxes.Keywords
This publication has 15 references indexed in Scilit:
- Injectivity Characteristics of EOR PolymersSPE Reservoir Evaluation & Engineering, 2009
- Comparison between a polyacrylamide and a hydrophobically modified polyacrylamide flood in a sandstone coreMaterials Science and Engineering: C, 2009
- Association and effective hydrodynamic thickness of hydrophobically associating polyacrylamide through porous mediaJournal of Applied Polymer Science, 2008
- Rheological properties of multisticker associative polyelectrolytes in semidilute aqueous solutionsJournal of Polymer Science Part B: Polymer Physics, 2004
- Unsteady-State Flow of Flexible Polymers in Porous MediaJournal of Colloid and Interface Science, 2001
- Water-soluble hydrophobically associating polymers for improved oil recovery: A literature reviewJournal of Petroleum Science and Engineering, 1998
- Adsorption of Hydrophobically Associating Polyacrylamides on ClayLangmuir, 1998
- Solution and adsorption properties of hydrophobically associating water-soluble polyacrylamidesColloids and Surfaces A: Physicochemical and Engineering Aspects, 1996
- Hydrophobically Associating Polymers1988
- Structurally Tailored Macromolecules for Mobility Control in Enhanced Oil Recovery1988