On the determination of the bending fatigue strength in and above the very high cycle fatigue regime of shot-peened gears
Open Access
- 28 June 2021
- journal article
- research article
- Published by Springer Nature in Forschung im Ingenieurwesen
- Vol. 86 (1) , 81-92
Abstract
Demands on modern gearboxes are constantly increasing, for example to comply with lightweight design goals or new CO2 thresholds. Normally, to increase performance requires making gearboxes and powertrains more robust. However, this increases the weight of a standard gearbox. The two trends therefore seem contradictory. To satisfy both of these goals, gears in gearboxes can be shot-peened to introduce high compressive residual stresses and improve their bending fatigue strength. To determine a gear’s tooth root bending fatigue strength, experiments are conducted up to a defined number of load cycles in the high cycle fatigue range. However, investigations of shot-peened gears have revealed tooth root fracture damage initiated at non-metallic inclusions in and above the very high cycle fatigue range. This means that a further reduction in bending load carrying capacity has to be expected at higher load cycles, something which is not covered under current standard testing conditions. The question is whether there is a significant decrease in the bending load carrying capacity and, also, if pulsating tests conducted at higher load cycles—or even tests on the FZG back-to-back test rig—are necessary to determine a proper endurance fatigue limit for shot-peened gears. This paper examines these questions.Keywords
Funding Information
- Bundesministerium für Wirtschaft und Technologie (IGF no. 16662 N)
- Forschungsgemeinschaft der Eisen und Metall verarbeitenden Industrie e.V. (A 220/2003)
- Technische Universität München
This publication has 30 references indexed in Scilit:
- Effects of inclusion size and stress ratio on fatigue strength for high-strength steels with fish-eye mode failureInternational Journal of Fatigue, 2013
- Investigation on defect distribution and its statistical evaluation for case hardened material statesInternational Journal of Fatigue, 2012
- Very high cycle fatigue behavior of a low strength welded joint at moderate temperatureInternational Journal of Fatigue, 2012
- Influence of shot peening on the fatigue life of Cu–Ni austempered ductile ironMaterials Science and Engineering: A, 2012
- Effect of nitrocarburizing and post-oxidation on fatigue behavior of 35CrMo alloy steel in very high cycle fatigue regimeInternational Journal of Fatigue, 2011
- Experimental estimation of crack initiation lives and fatigue limit in subsurface fracture of a high carbon chromium steelInternational Journal of Fatigue, 2006
- Effect of inclusion on subsurface crack initiation and gigacycle fatigue strengthInternational Journal of Fatigue, 2002
- On ‘multi‐stage’ fatigue life diagrams and the relevant life‐controlling mechanisms in ultrahigh‐cycle fatigueFatigue & Fracture of Engineering Materials & Structures, 2002
- Mechanism of fatigue failure in ultralong life regimeFatigue & Fracture of Engineering Materials & Structures, 2002
- On the life‐controlling microstructural fatigue mechanisms in ductile metals and alloys in the gigacycle regimeFatigue & Fracture of Engineering Materials & Structures, 1999