Experimental Investigation on the Perturbation Length for Air–Water Flow Upstream and Downstream of U-Bends
Open Access
- 27 May 2022
- journal article
- research article
- Published by Frontiers Media SA in Frontiers in Energy Research
- Vol. 10
Abstract
In this work, the perturbation length of vertical U-bend effects on the air–water two-phase flow in their adjacent straight tubes was investigated experimentally at ambient pressure and temperature. The experimental database covered test sections with three inner diameters of U-tubes (9, 12, and 16 mm), two curvature ratios (8.33 and 12.5), and two orientations (downward and upward). The air and water superficial velocities varied from 0.18 to 25.11 m/s and from 0.11 to 1.98 m/s, respectively. The dissipation of U-bend effects in the regions upstream and downstream of U-bends is characterized by the variation regularities of segmental pressure gradients along the contiguous straight tubes. It was found that the significant value of the dimensionless perturbation length (Lp/D) is less than 60 for the experimental conditions in this study. The influences of the inlet volume void fraction, two-phase mixed Froude number, mixed Weber number, and mixed Dean number on dimensionless perturbation length (Lp/D) are similar. With the increase in these parameters, Lp/D presents a unimodal distribution which first increases and then decreases. The maximum value of Lp/D takes place at a volume void fraction of around 90%. New dimensionless correlations to predict the influence length of U-bends on the straight tubes upstream and downstream have been provided. The prediction errors of 80% of data are within ± 30% compared with the present experimental data.Keywords
Funding Information
- National Natural Science Foundation of China
- Natural Science Foundation of Shandong Province
- Shandong Jianzhu University
This publication has 36 references indexed in Scilit:
- Two-phase flow visualization and pressure drop measurements of HFO-1234yf and R-134a refrigerants in horizontal return bendsExperimental Thermal and Fluid Science, 2012
- Two-phase flow behaviour and pressure drop of R134a in a smooth hairpinInternational Journal of Heat and Mass Transfer, 2012
- Hydrodynamics of lube oil–water flow through 180° return bendsChemical Engineering Science, 2011
- Two–Phase Pressure Drops in Adiabatic Horizontal Circular Smooth U-Bends and Contiguous Straight Pipes (RP-1444)HVAC&R Research, 2010
- Prediction and simulation of two-phase pressure drop in return bendsInternational Journal of Refrigeration, 2009
- An improved correlation for two-phase pressure drop of R-22 and R-410A in 180° return bendsApplied Thermal Engineering, 2008
- Two-phase slug flow across small diameter tubes with the presence of vertical return bendInternational Journal of Heat and Mass Transfer, 2005
- Measurements and correlations of frictional single-phase and two-phase pressure drops of R-410A flow in small U-type return bendsInternational Journal of Heat and Mass Transfer, 2004
- Two-phase flow pattern in small diameter tubes with the presence of horizontal return bendInternational Journal of Heat and Mass Transfer, 2003
- Flow Behavior and Pressure Drop of Two-Phase Flow through C-Shaped Bend in Vertical Plane, (I)Journal of Nuclear Science and Technology, 1980