Experimental Results of a Residential House Fire Test on Tenability: Temperature, Smoke, and Gas Analyses
- 6 December 2013
- journal article
- Published by Wiley in Journal of Forensic Sciences
- Vol. 59 (1) , 139-154
Abstract
A fire experiment conducted in a British 1950s‐style house is described. Measurements of temperature, smoke, CO, CO2, and O2 were taken in the Lounge, stairwell, and front and back bedrooms. The front bedroom door was wedged open, while the door to the back bedroom was wedged closed. Contrary to expectations and despite the relatively small fire load, analysis and hazard calculations show permeation of toxic fire gases throughout the property with lethal concentrations of effluent being measured at each sampling point. A generally poor state of repair and missing carpets in the upper story contributed to a high degree of gas and smoke permeation. The available egress time was calculated as the time before the main escape route became impassable. Given known human responses to fire, such an incident could have caused fatalities to sleeping or otherwise immobile occupants.Keywords
This publication has 16 references indexed in Scilit:
- Assessment of the fire toxicity of building insulation materialsEnergy and Buildings, 2011
- RSET/ASET, a flawed concept for fire safety assessmentFire and Materials, 2010
- Effects of the material and fire conditions on toxic product yields2010
- Fire toxicity2010
- Comparison of toxic product yields from bench-scale to ISO roomFire Safety Journal, 2009
- A Relative Time Analysis of the Performance of Residential Smoke Detection TechnologiesFire Technology, 2008
- Factors affecting the combustion toxicity of polymeric materialsPolymer Degradation and Stability, 2007
- The effect of temperature and ventilation condition on the toxic product yields from burning polymersFire and Materials, 2007
- Performance of home smoke alarms analysis of the response of several available technologies in residential fire settings2007
- Thermal degradation and flame retardance in copolymers of methyl methacrylate with diethyl(methacryloyloxymethyl)phosphonatePolymer Degradation and Stability, 2000