Densification behaviour of pure copper processed through cold pressing and binder jetting under different atmospheres
Authors:
- 25 January 2022
- journal article
- research article
- Published by Emerald Publishing in Rapid Prototyping Journal
- Vol. 28 (6) , 1023-1039
Abstract
Purpose: Binder jetting is a promising route to produce complex copper components for electronic/thermal applications. This paper aims to lay a framework for determining the effects of sintering parameters on the final microstructure of copper parts fabricated through binder jetting. Design/methodology/approach: The knowledge gained from well-established powder metallurgy processes was leveraged to study the densification behaviour of a fine high-purity copper powder (D50 of 3.4 µm) processed via binder jetting, by performing dilatometry and microstructural characterization. The effects of sintering parameters on densification of samples obtained with a commercial water-based binder were also explored. Findings: Sintering started at lower temperature in cold-pressed (∼680 °C) than in binder jetted parts (∼900 °C), because the strain energy introduced by powder compression reduces the sintering activation energy. Vacuum sintering promoted pore closure, resulting in greater and more uniform densification than sintering in argon, as argon pressure stabilizes the residual porosity. About 6.9% residual porosity was obtained with air sintering in the presence of graphite, promoting solid-state diffusion by copper oxide reduction. Originality/value: This paper reports the first systematic characterization of the thermal events occurring during solid-state sintering of high-purity copper under different atmospheres. The results can be used to optimize the sintering parameters for the manufacturing of complex copper components through binder jetting.Keywords
This publication has 46 references indexed in Scilit:
- Characterization of the swelling during sintering of uniaxially pressed copper powders by in situ X-ray microtomographyJournal of Materials Science, 2014
- Atmosphere sintering2010
- Low sintering temperature of MgTiO3 for type I capacitorsJournal of the European Ceramic Society, 2005
- Sintering of copper nanopowders under hydrogen: an in situ X-ray diffraction analysisMaterials Science and Engineering: A, 2003
- Reduction of copper oxide with graphite by mechanical alloyingJournal of Materials Research, 1999
- Liquidlike sintering behavior of nanometric Fe and Cu powders: Experimental approachMetallurgical and Materials Transactions A, 1998
- Influence of carbon on the enhanced oxygen loss in copper oxide filmsApplied Physics Letters, 1991
- On the corrosion of copper in pure waterCorrosion Science, 1989
- Thermodynamic properties of ethanol at atmospheric pressureJournal of Engineering Physics and Thermophysics, 1984
- The Reduction of Copper Oxide by Carbon Monoxide and the Catalytic Oxidation of Carbon Monoxide in the Presence of Copper and Copper OxideThe Journal of Physical Chemistry, 1923