Ti/C‐3Ni/Al as a Replacement Time Delay Composition
- 7 November 2013
- journal article
- research article
- Published by Wiley in Propellants, Explosives, Pyrotechnics
- Vol. 39 (1) , 138-147
Abstract
Replacement reactive systems for the tungsten delay composition (W/BaCrO4/KClO4/diatomaceous earth) are needed due to recent concerns over the toxicity of hexavalent chromium and perchlorates. Systems based on condensed phase reactions, that are typically used in combustion synthesis (e.g., Ti/C or Ni/Al) are of interest as replacements due to their wide range of combustion velocities and potentially low environmental impact. In this work, the combustion characteristics of the Ti/C‐3Ni/Al reactive system were examined in microchannels with inner diameters ranging from 3.0–6.0 mm (i.e., similar to that of a common delay housing). It was found that this reactive system could be tailored to overcome the heat losses associated with small diameter microchannels by changing the relative amounts of Ti/C and 3Ni/Al. At 40 wt.‐% Ti/C content, the failure diameter was found to be between 3.0 and 4.0 mm, while at 30 wt.‐% Ti/C the failure diameter was between 4.8 and 6.0 mm. Measured combustion temperatures in metal microchannels were approximately 1700 K while those of unconfined pellets were around 100 K greater. Increasing Ti/C content resulted in faster combustion velocities while decreasing microchannel diameter resulted in slower combustion velocities. At these small sizes the effects of adding a thermal barrier (specifically Grafoil™) to minimize radial heat losses to the microchannel were shown to be minimal with respect to combustion velocity. The Ti/C‐3Ni/Al system was shown to be a suitable delay fuze composition with tunable combustion velocities ranging from 2.1–38.1 mm s−1 in aluminum microchannels with diameters ranging from 4.0–6.0 mm.Keywords
Funding Information
- US Army RDECOM Environmental Quality Technology Program (#W15QKN-09-C-0121)
This publication has 16 references indexed in Scilit:
- Development and Performance of the W/Sb2O3/KIO4/Lubricant Pyrotechnic Delay in the US Army Hand‐Held SignalPropellants, Explosives, Pyrotechnics, 2012
- Manganese as Fuel in Slow‐Burning Pyrotechnic Time Delay CompositionsPropellants, Explosives, Pyrotechnics, 2010
- Sb6O13 and Bi2O3 as Oxidants for Si in Pyrotechnic Time Delay CompositionsPropellants, Explosives, Pyrotechnics, 2007
- Effects of TiC addition on combustion synthesis of NiAl in SHS modeJournal of Alloys and Compounds, 2005
- Investigation of Slow‐Propagation Tungsten Delay MixturesPropellants, Explosives, Pyrotechnics, 1997
- Combustion synthesis of advanced materials: Part I. Reaction parametersProgress in Materials Science, 1995
- Reactive formation of coatings at boron carbide interface with Ti and Cr powdersJournal of the European Ceramic Society, 1995
- Combustion synthesis of TiB and TiB2 under vacuumJournal of Materials Science Letters, 1994
- Combustion synthesis of advanced materialsChemical Engineering Science, 1992
- Temperature Profile Analysis in Combustion Synthesis: II, Experimental ObservationsJournal of the American Ceramic Society, 1992