Iron and steelmaking wastes as catalyst element sources for highly reactive coke production: effects on thermoplasticity, reactivity, mechanical strength, and blast furnace CO2 mitigation potential
Preprint
- 31 July 2026
- preprint
- Published by Elsevier in SSRN Electronic Journal
Abstract
Reducing greenhouse gas (GHG) emissions, improving energy efficiency, and recycling steelmaking wastes are pressing needs in the steel industry. Highly reactive coke (HRC), produced by carbonizing coal blends with a catalyst source, is a strategic technology for blast furnaces (BF). HRC can address these challenges by lowering the thermal reserve zone (TRZ) temperature, hence decreasing coke rate and GHG emissions. This study investigates the use of iron and steelmaking wastes as catalyst element source (CES), namely mill scale (MS), basic oxygen furnace sludge (BOFS), BF sludge (BFS), and a ferrous waste blend (FWB), as substitutes for iron ore (IO) in HRC production. Pyrolysis tests revealed that each CES produced a distinctive thermal decomposition profile, with the extent of iron oxide reduction and devolatilization attenuation depending on iron oxide speciation and particle size. MS caused significantly less fluidity degradation than IO, preserving the parent coal thermoplastic properties and yielding HRC with superior mechanical strength (I600 = 64.2% vs. 37.5% for IO). BOFS achieved the highest reactivity (gasification onset temperature Ts = 877 °C, conversion = 76.9%, CRI = 51.4%), attributed to its fine particle size (SMD = 0.010 mm) and CaO content (15.3%) providing dual catalytic pathways. A multivariate regression model incorporating %Fe0, %CaO, surface area, and carbon source reactivity was developed from 24 HRC samples, yielding R2 = 0.97 and 0.81 for conversion and Ts prediction, respectively. Applied to the five HRC of this study, the model reproduced the experimental results with R2 = 0.94 and 0.83. Rist diagram modeling indicated that replacing 40 kg/tHM of nut coke with waste-based HRC could reduce carbon consumption by up to 30.4 kg/tHM. Mass balance showed that MS and BFS can be used without restrictions regarding deleterious elements, while Zn inputs from BOFS-bearing HRC remain far below typical BF limits.Keywords
This publication has 28 references indexed in Scilit:
- Effects and mechanism of using ferro-coke in an ironmaking blast furnace – A virtual experimentFuel, 2024
- Automated procedure for coke microstructural characterization in imagej software aiming industrial applicationFuel, 2021
- Hydrometallurgical Processes for the Recovery of Metals from Steel Industry By-Products: A Critical ReviewJournal of Sustainable Metallurgy, 2020
- The study of the Ca dispersion in coke and effect of Ca and Fe on the coke reactivity using the sole heated oven cokesFuel, 2019
- Thermal decomposition of calcium carbonate (calcite polymorph) as examined by in-situ high-temperature X-ray powder diffractionJournal of Physics and Chemistry of Solids, 2019
- On the reduction behavior, structural and mechanical features of iron ore-carbon briquettesFuel Processing Technology, 2017
- Structure and Reactivity of Coal2015
- Low CO2 emission technologies for iron and steelmaking as well as titania slag productionMinerals Engineering, 2007
- Swelling and plastic properties of coal devolatilized at elevated pressures: an examination of the influences of coal typeFuel, 1986
- A dual graphic representation of the blast-furnace mass and heat balancesJOM, 1967