A simplified model for natural-gas vehicle catalysts with honeycomb and foam substrates
Authors:
- 1 June 2009
- journal article
- research article
- Published by SAGE Publications in Proceedings of the Institution of Mechanical Engineers, Part D: Journal of Automobile Engineering
- Vol. 223 (6) , 819-834
Abstract
A mathematical model is developed for the simulation of the chemical and transport phenomena in three-way catalysts for natural-gas vehicles, with honeycomb and foam substrates. The chemical phenomena are modelled on the basis of a simplified approach, which assumes that pollutant conversion is governed by oxygen storage and release dynamics. The transport phenomena, i.e. heat transfer, gas-phase mass transfer, washcoat diffusion, and pressure drop, are modelled on the basis of correlations adapted from the literature. The model is validated using lambda scan tests and a cold-start driving cycle, carried out with a honeycomb catalyst and a ceramic foam catalyst. The experimental data show a decline in methane conversion for lean mixtures, which is modelled by an inhibition term of methane oxidation from nitric oxide. The proposed model may capture the performance of both substrates with sufficient accuracy, both under cold-start and under hot-mode conditions. The model-based comparison of the two substrates shows that the ceramic foam presents inferior carbon monoxide conversion in the extra-urban part of the cycle. Although the gas-phase mass transfer in the ceramic foam is faster than with the honeycomb monolith, diffusion in the washcoat pores is much slower. As a result, the mass-transfer-limited conversion efficiency of the foam is lower. This is primarily attributed to the higher washcoat thickness of the foam sample tested.Keywords
This publication has 29 references indexed in Scilit:
- A Simplified Three-Way Catalyst Model for Transient Hot-Mode Driving CyclesIndustrial & Engineering Chemistry Research, 2009
- Pressure drop measurements and modeling on SiC foamsChemical Engineering Science, 2007
- A discussion on transport phenomena and three-way kinetics of monolithic convertersChemical Engineering Science, 2006
- One-dimensional automotive catalyst modelingProgress in Energy and Combustion Science, 2005
- Three-Way Catalytic Converter Modeling as a Modern Engineering Design ToolJournal of Engineering for Gas Turbines and Power, 2004
- Complete oxidation of methane at low temperature over noble metal based catalysts: a reviewApplied Catalysis B: Environment and Energy, 2002
- Oxygen Storage Modeling in Three-Way Catalytic ConvertersIndustrial & Engineering Chemistry Research, 2002
- Properties of ceramic foam catalyst supports: pressure dropApplied Catalysis A: General, 2000
- Development and application range of mathematical models for 3-way catalytic convertersApplied Catalysis B: Environment and Energy, 1997
- Kinetic Study of Carbon Monoxide and Propylene Oxidation on Platinum CatalystsProduct R&D, 1973