Effect of cavity surface coating on mold temperature variation and the quality of injection molded parts
Authors:
- Shia-Chung ChenSCShia-Chung Chen
- Yi ChangYCYi Chang
- Yeon-Pun ChangYCYeon-Pun Chang
- Yen-Chen ChenYCYen-Chen Chen
- Chia-Yen TsengCTChia-Yen Tseng
- 1 December 2009
- journal article
- research article
- Published by Elsevier in International Communications in Heat and Mass Transfer
- Vol. 36 (10) , 1030-1035
Abstract
No abstract availableKeywords
Funding Information
- Ministry of Education
- Chung Yuan Christian University
This publication has 8 references indexed in Scilit:
- Dynamic Mold Surface Temperature Control Using Induction and Heater Heating Combined with Coolant CoolingInternational Polymer Processing, 2006
- Simulation of infrared rapid surface heating for injection moldingInternational Journal of Heat and Mass Transfer, 2006
- High‐frequency proximity heating for injection molding applicationsPolymer Engineering & Science, 2006
- Dynamic mold surface temperature control using induction heating and its effects on the surface appearance of weld lineJournal of Applied Polymer Science, 2006
- 3D numerical simulation of transient temperature field for lens mold embedded with heatersInternational Communications in Heat and Mass Transfer, 2005
- Investigations on the Weldline Tensile Strength of Thin-wall Injection Molded PartsJournal of Reinforced Plastics and Composites, 2004
- Simulations and Applications of Injection-Compression MoldingJournal of Reinforced Plastics and Composites, 1999
- Reducing residual stresses in molded partsPolymer Engineering & Science, 1989