Single-phase friction riveting: metallic rivet deformation, temperature evolution, and joint mechanical performance
Open Access
- 5 November 2019
- journal article
- research article
- Published by Springer Nature in Welding in the World
- Vol. 64 (1) , 47-58
Abstract
The present work explores the feasibility of single-phase friction riveting on unreinforced thermoplastics. In single phase, the load is kept constant throughout the process, avoiding the forging phase with higher axial force, used in the conventional process. This process variant can constitute an answer when payload restrictions exist. The results demonstrate the feasibility of single-phase friction riveting on unreinforced polyetherimide plates joined by AA2024 rivets with 5 mm of diameter. A Box-Behnken design of experiments and analysis of variance were used to set parameter matrix and understand the correlations between parameters and joint properties. A large variation of the mechanical energy input was observed (151–529 J). Over-deformation and material rupture were observed in higher energy conditions. Lower energy input yielded a bell-shaped rivet plastic deformation, corresponding to the best performance. The maximum process temperatures varied between 461 and 509 °C. This friction riveting process variant allowed a considerable high mechanical strength to be achieved, with ultimate tensile force of 7486 N, comparable with the two-phase friction riveting process, albeit applying lower axial forces, such as 2400 N. Within the investigated conditions, this study proves the feasibility of the single-phase process, achieving good global mechanical performance and energetically efficient conditions, without forging phase.Keywords
Funding Information
- Helmholtz Association (VH-NG-626)
- BMVIT
- TAKE OFF
This publication has 24 references indexed in Scilit:
- Joining of Polymer‐Metal Hybrid Structures2017
- Ultrasonic joining: A novel direct-assembly technique for metal-composite hybrid structuresMaterials Letters, 2016
- Microstructure and mechanical performance of metal-composite hybrid joints produced by FricRivetingComposites Part B: Engineering, 2015
- Influence of process parameters on mechanical performance and bonding area of AA2024/carbon-fiber-reinforced poly(phenylene sulfide) friction spot single lap jointsMaterials & Design, 2015
- Friction Riveting (FricRiveting) as a new joining technique in GFRP lightweight bridge constructionConstruction and Building Materials, 2015
- Mechanical and failure behaviour of hybrid polymer–metal staked jointsMaterials & Design (1980-2015), 2013
- Henry Granjon Prize Competition 2009 Winner Category A: “Joining and Fabrication Technology” Friction Riveting: development and analysis of a new joining technique for polymer-metal multi-material structuresWelding in the World, 2011
- New Trends and Developments in Automotive Industry2011
- Joining of polymers and polymer–metal hybrid structures: Recent developments and trendsPolymer Engineering & Science, 2009
- Adhesively-bonded joints and repairs in metallic alloys, polymers and composite materials: Adhesives, adhesion theories and surface pretreatmentJournal of Materials Science, 2004