Real‐time diagnosis of co‐injection molding using ultrasound
- 1 August 2007
- journal article
- research article
- Published by Wiley in Polymer Engineering & Science
- Vol. 47 (9) , 1491-1500
Abstract
Co‐injection molding, also known as sandwich molding, is a process in which two or more polymers are laminated together in a mold cavity. Integrated ultrasonic sensors embedded into a mold insert of a co‐injection‐molding machine have been used for real‐time, nonintrusive, and nondestructive diagnosis of co‐injection‐molding processes. Diagnosis of core arrival, core flow speed, part solidification, part detachment from the mold, thickness of skin and core, and core length at the mold was demonstrated. It is found that core flow speed and peak cavity pressure monotonically increased and decreased with the core volume percentage, respectively. Thicknesses of the skin and core of the molded part were estimated using the presented ultrasonic technique during molding with an accuracy better than ±17%. In addition, the core length had correlation with core thickness, core flow speed, and peak cavity pressure. Among them, the core thickness measured by the ultrasonic technique had the better correlation. This technique enables process optimization, the maximum process efficiency, and in‐process quality assurance of the molded parts. POLYM. ENG. SCI., 47:1491–1500, 2007. © 2007 Society of Plastics EngineersKeywords
This publication has 20 references indexed in Scilit:
- Interface development and encapsulation in simultaneous coinjection molding of disk. II. Two‐dimensional simulation and experimentJournal of Applied Polymer Science, 2003
- Co‐injection molding: Effect of processing on material distribution and mechanical properties of a sandwich molded platePolymer Engineering & Science, 2000
- Structural hierarchy developed in co-injection molded polystyrene/polypropylene partsPolymer, 1999
- Observation of the polymer melt flow in injection molding process using co-injection molding techniqueInternational Communications in Heat and Mass Transfer, 1994
- Ultrasonic investigation of semicrystalline polymers: study of poly(ethylene terephthalate)Polymer, 1991
- Co‐injection molding of reinforced polymersPolymer Composites, 1983
- A basic experimental study of sandwich injection molding with sequential injectionPolymer Engineering & Science, 1980
- Recycling plastics by two‐shot moldingPolymer Engineering & Science, 1975
- An experimental study of sandwich injection molding of two polymer melts using simultaneous injectionPolymer Engineering & Science, 1975
- Flow visualization for injection molding of polyethylene and polystyrene meltsPolymer Engineering & Science, 1974