Knoop Microhardness Anisotropy and the Indentation Size Effect on the Basal Plane of Single‐Crystal Alumina (Sapphire)
Authors:
- 1 February 2002
- journal article
- Published by Wiley in Journal of the American Ceramic Society
- Vol. 85 (2) , 415-422
Abstract
The Knoop microhardness anisotropy profile was determined for the basal plane of a Czochralski grown alumina single crystal for indentation test loads from 100 through 1000 g. Microhardness maxima occur at low indentation test loads for the long axis of the Knoop indenter parallel to the 〈2[Onemacr][Onemacr]0〉. Minima exist for the long axis parallel to the 〈10[Onemacr]0〉. This low indentation test load profile is attributed to slip on the primary slip system, the (0001)〈[Onemacr][Onemacr]20〉, as previously noted by Brookes and co‐workers. The degree of the microhardness anisotropy decreases for higher indentation test loads. This results from the activation of multiple slip systems to accommodate the greater amounts of plastic flow required by the larger indentation sizes. The microhardness profile becomes more uniform with increasing indentation test load until the Knoop microhardness approaches a test‐load‐independent, orientation‐independent microhardness of 1167 ± 34 kg/mm 2 . The indentation size effect (ISE) was further investigated through lubricated indentation hardness measurements. Lubrication of the test specimen surface significantly reduces the ISE. Results indicate that friction between the test specimen surface and the indenter facets is a major portion of the ISE.Keywords
This publication has 28 references indexed in Scilit:
- Sliding Wear of Oxide Ceramics at Elevated TemperaturesJournal of the American Ceramic Society, 1995
- Size dependent hardness of silver single crystalsJournal of Materials Research, 1995
- The frictional component in microhardness testing of intermetallicsScripta Metallurgica et Materialia, 1993
- Energy principle of the indentation-induced inelastic surface deformation and hardness of brittle materialsActa Metallurgica et Materialia, 1993
- Energy principle of indentation contact: The application to sapphireJournal of Materials Research, 1993
- A friction effect in low-load hardness testing of copper and aluminiumJournal of Materials Science, 1990
- Microhardness of SiO2 Glass in Various EnvironmentsJournal of the American Ceramic Society, 1987
- Use of the Indentation Size Effect on Microhardness for Materials Characterization1985
- Anisotropy in the hardness of single crystalsProceedings of the Royal Society of London. A. Mathematical and Physical Sciences, 1971
- Friction and Wear of Single-Crystal Sapphire Sliding on SteelJournal of Applied Physics, 1962