Influence of the 3D architecture and surface roughness of SiOC anodes on bioelectrochemical system performance: a comparative study of freeze-cast, 3D-printed, and tape-cast materials with uniform composition
Authors:
- Pedro Da Rosa BraunPBPedro Da Rosa Braun
- Michaela WilhelmMWMichaela Wilhelm
Open Access
- 5 February 2024
- journal article
- research article
- Published by Springer Nature in Materials for Renewable and Sustainable Energy
- Vol. 13 (1) , 81-96
Abstract
3D-printed anodes for bioelectrochemical systems are increasingly being reported. However, comparisons between 3D-printed anodes and their non-3D-printed counterparts with the same material composition are still lacking. In addition, surface roughness parameters that could be correlated with bioelectrochemical performance are rarely determined. To fill these gaps, slurries with identical composition but different mass fractions were processed into SiOC anodes by tape-casting, freeze-casting, or direct-ink writing. The current generation was investigated using electroactive biofilms enriched with Geobacter spp. Freeze-cast anodes showed more surface pores and the highest surface kurtosis of 5.7 ± 0.5, whereas tape-cast and 3D-printed anodes showed a closed surface porosity. 3D-printing was only possible using slurries 85 wt% of mass fraction. The surface pores of the freeze-cast anodes improved bacterial adhesion and resulted in a high initial (first cycle) maximum current density per geometric surface area of 9.2 ± 2.1 A m−2. The larger surface area of the 3D-printed anodes prevented pore clogging and produced the highest current density per geometric surface area of 12.0 ± 1.2 A m−2. The current density values of all anodes are similar when the current density is normalized over the entire geometric surface as determined by CT-scans. This study highlights the role of geometric surface area in normalizing current generation and the need to use more surface roughness parameters to correlate anode properties, bacterial adhesion, and current generation.Keywords
Funding Information
- Deutsche Forschungsgemeinschaft (GRK 1860)
- Helmholtz-Gemeinschaft (Tapping nature’s potential for sustainable production and a healthy environment)
- Universität Bremen
This publication has 73 references indexed in Scilit:
- Influence of anode potentials on selection of Geobacter strains in microbial electrolysis cellsBioresource Technology, 2013
- Layered corrugated electrode macrostructures boost microbial bioelectrocatalysisEnergy & Environmental Science, 2012
- Revealing the electrochemically driven selection in natural community derived microbial biofilms using flow-cytometryEnergy & Environmental Science, 2011
- Microbial Communities and Electrochemical Performance of Titanium-Based Anodic Electrodes in a Microbial Fuel CellApplied and Environmental Microbiology, 2011
- Selecting Anode-Respiring Bacteria Based on Anode Potential: Phylogenetic, Electrochemical, and Microscopic CharacterizationEnvironmental Science & Technology, 2009
- Phylogenetic Comparison of the Methanogenic Communities from an Acidic, Oligotrophic Fen and an Anaerobic Digester Treating Municipal Wastewater SludgeApplied and Environmental Microbiology, 2008
- Marine microbial fuel cell: Use of stainless steel electrodes as anode and cathode materialsElectrochimica Acta, 2007
- Evaluation of procedures to acclimate a microbial fuel cell for electricity productionApplied Microbiology and Biotechnology, 2005
- Conductive Ceramic Foams from Preceramic PolymersJournal of the American Ceramic Society, 2001
- Processing Strategy for Producing Highly Anisotropic Silicon NitrideJournal of the American Ceramic Society, 1995