Fabrication and Performance of Silicon-Embedded Permanent-Magnet Microgenerators
Authors:
- 8 December 2009
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Microelectromechanical Systems
- Vol. 19 (1) , 4-13
Abstract
This paper focuses on the design, fabrication, and characterization of silicon-packaged permanent-magnet (PM) microgenerators. The use of silicon packaging favors fine control on shape and dimensions in batch fabrication and provides a path toward high rotational speeds (1Mr/min), a requirement for ultimate compactness of microgenerators. The successful silicon packaging of these microgenerators consisted of three essential elements: (1) a winding scheme allowing both nonplanar fabrication and through-wafer interconnects; (2) laminations built into the silicon for enhanced electrical performance; and (3) a balancing scheme for the heavy PM rotor to ensure its maximum performance. The devices were fabricated using bonded silicon wafers, integrated magnetics, and an electroplated metal. The mechanical strength of the 12-mm-diameter silicon-packaged PM rotors was evaluated at high rotational speeds using an external spindle drive. Speeds up to 200000 r/min were achieved prior to a mechanical rotor failure. The generators were electrically characterized, and an output power in excess of 1 W across a resistive load of 0.32 ¿ was measured at a maximum speed. A 225% power increase was also experimentally determined due to the addition of a laminated stator back iron.Keywords
This publication has 22 references indexed in Scilit:
- High-Speed Operation of a Gas-Bearing Supported MEMS-Air TurbineJournal of Tribology, 2009
- High temperature operation of multi-watt, axial-flux, permanent-magnet microgeneratorsSensors and Actuators A: Physical, 2008
- A microfluidic-electric package for power MEMS generators2008 IEEE 21st International Conference on Micro Electro Mechanical Systems, 2008
- Review of Microscale Magnetic Power GenerationIEEE Transactions on Magnetics, 2007
- Microfabricated High-Speed Axial-Flux Multiwatt Permanent-Magnet Generators—Part I: ModelingJournal of Microelectromechanical Systems, 2006
- Development of high-speed micro-gas bearings for three-dimensional micro-turbo machinesJournal of Micromechanics and Microengineering, 2005
- Analysis and optimization of vertically oriented, through-wafer, laminated magnetic cores in siliconJournal of Micromechanics and Microengineering, 2005
- Axial-flux permanent magnet machines for micropower generationJournal of Microelectromechanical Systems, 2005
- Millimeter-Scale, Micro-Electro-Mechanical Systems Gas Turbine EnginesJournal of Engineering for Gas Turbines and Power, 2004
- Ultralow-profile micromachined power inductors with highly laminated Ni/Fe cores: Application to low-megahertz DC-DC convertersIEEE Transactions on Magnetics, 2003